TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM69A: BOOTING FROM EMMC WITHOUT SD CARD

    Gokul Praveen
    Gokul Praveen
    Part Number: AM69A Other Parts Discussed in Thread: AM69 Tool/software: How to boot from eMMC without SD card?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Undeclared Identifier for MCU GPIO Interrupt Routers

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I am trying to upgrade my project to use the new MCU+ SDK 10.1 and I'm running into a compilation error saying that the interrupt router number is undeclared. This…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x (ALV) / AM335x Design Recommendations / Custom board hardware design - Schematics review checklists

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62L Tool/software: Hi Board designers The AM64x, AM62x, AM62Ax, AM62D-Q1, AM62Px and AM62L custom board Schematic review Checklist application note provides a supplemental design check…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: Deploy MMYOLO on AM62A, YOLOV8 nano as example.

    Adam Hua
    Adam Hua
    Part Number: AM62A7-Q1 Tool/software: MMYOLO is an open source repo for quick yolo model evaluation. Deployment MMYOLO on TI processor like AM6x or TDAx requires some modifications on this repo. This FAQ uses yolov8 as example to demonstrate how to…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to SysConfig-PinMux IOSET and Voltage Conflict

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Tool/software: Hi TI Experts, I see IOSET option and Voltage Conflict indication while using SysConfig-PinMux. Can you provide additional inputs on the IOSET and Voltage configuration
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Incorrect auto-generated MAC port 2 PHY configuration

    Nitika Verma
    Nitika Verma
    Part Number: SK-AM64B Other Parts Discussed in Thread: DP83869 , SYSCONFIG Tool/software: The two Ethernet Ports on SK-AM64x are connected to two separate Gigabit Ethernet PHY Transceivers DP83867. On enabling MAC Port 2 in SK-AM64x networking…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to passive components values, tolerance, voltage rating

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, 1. In the SK/EVM i see 49.9K resistor used. Can i use a standard value instead 2. In the SK/EVM i see a number of resistors used with 1% tolerance for pullups and series resistors. Can i use standard…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design – Queries related to Residual Voltage, Detection and supply decay

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6594-Q1 , AM62P Tool/software: HI TI experts, I have the below queries related to residual voltage 1. What are the causes for Residual Voltage 2. Effect of Residual Voltage on…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: SDIO driver strength change

    Biao Li
    Biao Li
    Part Number: AM62A7-Q1 Other Parts Discussed in Thread: AM62A7 Tool/software: Hi Expert, Customer was doing EMC test, it was found that the EMMC CLOCK exceeded the standard by 10dB at 1.8GHz and 1.6GHz. Can the output strength capability of the…
    • 9 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198401 Discussions
  • Not Answered

    AM387x/TI814x/DM814x PINCNTLx register description? 0 Locked

    291 views
    3 replies
    Latest over 13 years ago
    by Ewald Schan
  • Not Answered

    Why the pins GP1_IO31 and GP1_IO30 are unconnected 0 Locked

    262 views
    1 reply
    Latest over 13 years ago
    by MarcPyne
  • Answered

    AM1808 EMIFA pin muxing 0 Locked

    205 views
    3 replies
    Latest over 13 years ago
    by Terry16065
  • Answered

    JPEG Encoder problem on DM3730 0 Locked

    372 views
    3 replies
    Latest over 13 years ago
    by Andrew Muehlfeld
  • Not Answered

    What powers the 5509A system clock PLL? 0 Locked

    695 views
    8 replies
    Latest over 13 years ago
    by Mark M
  • Not Answered

    EVMAM1808 error: bq27000 GND & GND_PACK opposite? 0 Locked

    424 views
    1 reply
    Latest over 13 years ago
    by jc-ti
  • Not Answered

    External USB emulator xdc100v2 for ARM+DSP development 0 Locked

    398 views
    1 reply
    Latest over 13 years ago
    by jc-ti
  • Answered

    Ethernet performance. 0 Locked

    173 views
    1 reply
    Latest over 13 years ago
    by Steven Connell
  • Answered

    Unable to read internal AM1806 registers with CCS 0 Locked

    725 views
    1 reply
    Latest over 13 years ago
    by Alan DeMars
  • Answered

    Clock.timerId can't work 0 Locked

    1033 views
    8 replies
    Latest over 13 years ago
    by Rashmi Tripathi
  • Answered

    DSPLink with 2.6.38 kernel 0 Locked

    450 views
    4 replies
    Latest over 13 years ago
    by Judson Wilson
  • Not Answered

    Audio/Video Sync with PTS support from decoder 0 Locked

    1367 views
    1 reply
    Latest over 13 years ago
    by Satish Arora
  • Not Answered

    Appro DM368 av_server 0 Locked

    843 views
    0 replies
    Started over 13 years ago
    by Mayank Agarwal
  • Answered

    How do I configure a CCS5 .cfg project file such that each core of a C6678 has is own section in MSMCSRAM for static variables? 0 Locked

    904 views
    4 replies
    Latest over 13 years ago
    by Nicholas Jankovic
  • Answered

    Does TSK_delete() call MEM_free() to free the stack in both cases? 0 Locked

    587 views
    6 replies
    Latest over 13 years ago
    by judahvang
  • Not Answered

    How to enable and use GP timer module in DM8168 0 Locked

    247 views
    3 replies
    Latest over 13 years ago
    by Satheesh babu s
  • Suggested Answer

    How to enable RMII mode in u-boot for TI8148 0 Locked

    646 views
    1 reply
    Latest over 13 years ago
    by Mugunthan V N
  • Not Answered

    Appro DM368-IPNC /dev/spidev0.0 not created 0 Locked

    376 views
    0 replies
    Started over 13 years ago
    by Mayank Agarwal
  • Not Answered

    Are there some test examples for C6670 CSL? 0 Locked

    341 views
    2 replies
    Latest over 13 years ago
    by fei wang71222
  • Not Answered

    Boot C5505 from NOR-flash 0 Locked

    759 views
    7 replies
    Latest over 13 years ago
    by ruzz
<>