TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] AM6422: How to Switch Back to External Clock After Clock Loss Detection

    Pratibha Singh
    Pratibha Singh
    Part Number: AM6422 Other Parts Discussed in Thread: AM6442 Tool/software: Hi, I am using the AM6442 Processor Evaluation Kit. We’ve been testing the Clock Loss Detection feature of the AM64x. We provided a 25 MHz external clock to the processor…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Custom board hardware design – Information on processor core, PLL, VDD_CORE, VDDR_CORE, VPP and other core supplies

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM620-Q1 , AM62P , SYSCONFIG , AM625 , AM623 , AM625-Q1 , AM6421 , SK-AM62B-P1 , AM6442 Tool/software: Hi TI Experts, Please share your inputs on processor core, thermal alert, VDD_CORE, VDDR_CORE…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Custom board hardware design – Information on PADCONFIG bits and PADCONFIG registers default values summary

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: SYSCONFIG , AM62A3 , AM62P , AM62D-Q1 Tool/software: Hi TI Experts, Could you please elaborate about PADCONFIG register bits and default configurations for PADCONFIG registers.
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design –SD card Interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM62P , SYSCONFIG , AM62P5-Q1 Tool/software: Hi TI Experts, Is there a list of design recommendations or commonly observed errors for SD card Interface during Custom board hardware design? Below…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable constructor / destructor attribute for A53 core using GCC

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I was using the __attribute__((constructor(x) / destructor(y)) property in C code for A53 core with GCC compiler. the GCC attribute is __attribute__((destructor…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to capture TIFS trace with AM62A Linux SDK

    Hong Guan64
    Hong Guan64
    Part Number: AM62A7 Other Parts Discussed in Thread: SK-AM62A-LP Tool/software: TIFS trace log is a useful debug tool to analyze TIFS firmware operations [1] [2]. There's an issue on capturing TIFS trace log from MAIN_UART1 port with AM62A Linux SDK…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM67: How do I enter PCIe TX compliance mode using Linux?

    Takuma Fujiwara
    Takuma Fujiwara
    Part Number: AM67 Tool/software: I would like to do a PCIe compliance test to see if my AM6x PCIe device meets the standards set by PCI-SIG. What is the procedure to run this test?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] DRA821U-Q1: How to enable RGMII2 on CPSW5G for TI EVM using the Native Linux Driver?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: DRA821U-Q1 Tool/software: How can I enable the RGMII2 interface from the CPSW5G Ethernet switch on the DRA821-Q1 TI EVM using the native Linux driver?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197866 Discussions
  • Not Answered

    DM365 IPNC 0 Locked

    1264 views
    4 replies
    Latest over 13 years ago
    by Raghu Kudva
  • Not Answered

    query regarding format 0 Locked

    133 views
    0 replies
    Started over 13 years ago
    by moidin suzan
  • Answered

    RAW Sockets 0 Locked

    784 views
    4 replies
    Latest over 13 years ago
    by Oliver Bull
  • Answered

    Example programs - OMAP-L137; CCSv3.3; DSP/BIOS 0 Locked

    381 views
    2 replies
    Latest over 13 years ago
    by sbartoszek
  • Not Answered

    I have a H.264 Encoder extended error code: 0xf4c8f2b4 0 Locked

    303 views
    1 reply
    Latest over 13 years ago
    by Veeranna Hanchinal
  • Not Answered

    can create 2 h264 decoders at the same time, in a dm365 application??? 0 Locked

    456 views
    1 reply
    Latest over 13 years ago
    by Yashwant Dutt
  • Answered

    RTFS and SYS/BIOS Support? 0 Locked

    3955 views
    24 replies
    Latest over 13 years ago
    by RIZUAN
  • Not Answered

    HDMI display failed on custom DM8168 board. 0 Locked

    467 views
    0 replies
    Started over 13 years ago
    by Lei Wong
  • Answered

    OMAP L138 IO: leakage at deepsleep/standby mode? 0 Locked

    1316 views
    4 replies
    Latest over 13 years ago
    by Anonymous
  • Discussion

    MexBIOS - software development tool for C2000 Locked

    265 views
    1 reply
    Latest over 13 years ago
    by David Friedland
  • Not Answered

    Kernel Boot Problem in my Board 0 Locked

    520 views
    5 replies
    Latest over 13 years ago
    by yi luo68719
  • Not Answered

    booting OMAP-L137 AM1707 EVM using USB for both uImage loading and filesystem 0 Locked

    295 views
    0 replies
    Started over 13 years ago
    by Yehuda Yehudai
  • Not Answered

    BUG in local_bh_enable at kernel/softirq.c 0 Locked

    512 views
    0 replies
    Started over 13 years ago
    by leon jiang
  • Answered

    how to re-make codec engine 0 Locked

    451 views
    2 replies
    Latest over 13 years ago
    by Bendney Yu
  • Answered

    Booting repeatedly after switching on the OMAP35X EVM 0 Locked

    329 views
    4 replies
    Latest over 13 years ago
    by yi luo68719
  • Not Answered

    C5515 I2C Timeout using CSL 0 Locked

    421 views
    1 reply
    Latest over 13 years ago
    by Sunil Kamath
  • Not Answered

    What is the mean of Reference size(12288 and 16384) in the regisrter of FFTC_QUEUE_X_LTE_FREQUENCY_SHIFT_REGISTER 0 Locked

    324 views
    1 reply
    Latest over 13 years ago
    by Sudhanand Dayalan
  • Answered

    I2C touch driver 0 Locked

    1060 views
    5 replies
    Latest over 13 years ago
    by 1258021
  • Suggested Answer

    DM3730 DDR Bit Swapping 0 Locked

    461 views
    3 replies
    Latest over 13 years ago
    by TimHarron
  • Not Answered

    UART CIR 0 Locked

    330 views
    1 reply
    Latest over 13 years ago
    by guanghui zhao
<>