TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How do I enable MAC Port based broadcast/multicast rate limiting?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    How to I enable MAC Port based broadcast/multicast rate limiting? and configuration?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to profile a GPIO toggled ISR , any example?

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VL Hello team, I need a baremetal pdk based example just to see the profiling time for interrupts via toggling of GPIO pin .Can you please show us how ?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625: what is the specific delay time requirement between the different power rail?

    Biao Li
    Biao Li
    Part Number: AM625 Hi Expert, In AM62 datasheet, I can find the power up sequence as below, but I can't find the specific delay time requirement. or there is no requirement as waveform B need delay with waveform A? BR, Biao
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM62X/SK-AM62A-LP: Testing MCAN External Loopback example using external transceiver TCAN1042D

    Aparna Patra
    Aparna Patra
    Part Number: SK-AM62A-LP Other Parts Discussed in Thread: SYSCONFIG How to test MCAN external loopback example on AM62x/AM62A using an external transceiver ?
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: Accelerate Transformer Models on TI SoCs.

    Pratik Kedar
    Pratik Kedar
    Part Number: TDA4VH-Q1 TIDL SDK Version : 9.1 I have downloaded transformer model (deit) from Tis Tools repos : https://github.com/TexasInstruments/edgeai-tidl-tools/blob/master/docs/tidl_fsg_vtfr.md#deit-transformer-example Facing issues while…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I get a valid param.yaml file for my TIDL deep learning model? The demos in edgeai-gst-apps throw errors on my model

    Reese Grimsley
    Reese Grimsley
    Other Parts Discussed in Thread: AM69A , AM68A I compiled a model for a device (AM62A, AM68A, AM69A, etc.) with edgeai-tidl-tools and compilation did not throw any errors. I want to evaluate my model on the EVM now, and I see edgeai-gst-apps is the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL-Q1: How to generate downstream PCIe interrupt from RC to EP

    Takuma Fujiwara
    Takuma Fujiwara
    Part Number: TDA4VL-Q1 Other Parts Discussed in Thread: AM68 , TDA4VM , TDA4VL , TDA4VH TDA4VL, TDA4VM, TDA4VH, and their respective AM6x device counterparts of AM68, TDA4VM, and AM69 all have the ability to generate a downstream PCIe interrupt from RC…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to boot SK-AM62B/SK-AM62A via Ethernet and flash U-boot and Linux binaries into eMMC via Ethernet ?

    Daolin Qiu
    Daolin Qiu
    Other Parts Discussed in Thread: SK-AM62B How do I boot an SK-AM62B or SK-AM62A using Ethernet and subsequently flash the required U-boot binaries and Kernel, DTB, and root filesystem to eMMC? The solution is divided into two sections: 1) This section…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM68: Enabling Arducam V3Link Camera kit on SK-AM68 and SK-AM69

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM68 Other Parts Discussed in Thread: SK-AM69 , , AM67 , AM68A , AM69A , AM67A How can I enable 4x IMX219 sensors using the mini fusion board from Arducam on SK-AM68, SK-AM69 and AM67? I am using SDK version 09.01.00.06 of the edge AI…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – eMMC MEMORY Interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Other Parts Discussed in Thread: AM62D-Q1 , AM62L , AM62P , AM62A7 , AM6442 , STRIKE , SK-AM62B-P1 , AM62P5-Q1 Hi TI Experts, Is there a list of design recommendations or commonly observed errors for eMMC MEMORY Interface during Custom board hardware…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198502 Discussions
  • Not Answered

    DM365 AF data format 0 Locked

    171 views
    0 replies
    Started over 13 years ago
    by Matteo Sassi
  • Answered

    Can I write some wrappers around codec? 0 Locked

    310 views
    2 replies
    Latest over 13 years ago
    by Chris Ring
  • Not Answered

    How to enable the "USB Webcam Gadget" 0 Locked

    1136 views
    0 replies
    Started over 13 years ago
    by kuan ting liu
  • Answered

    AM335x complementary devices.... 0 Locked

    216 views
    1 reply
    Latest over 13 years ago
    by Robert Finger
  • Answered

    If a task and a HWI use the same semaphore must I declare the semaphore as volatile? 0 Locked

    404 views
    1 reply
    Latest over 13 years ago
    by Karl Wechsler
  • Discussion

    problem in sensing temperature Locked

    337 views
    0 replies
    Started over 13 years ago
    by manisha kodag
  • Discussion

    problem in sensing temperature Locked

    154 views
    0 replies
    Started over 13 years ago
    by manisha kodag
  • Not Answered

    mtd->read returned ECC error 0 Locked

    393 views
    0 replies
    Started over 13 years ago
    by Matteo Ceruti
  • Answered

    L4/L3 memory map unable to access after loading BIOS example in CCS 5.1. 0 Locked

    702 views
    6 replies
    Latest over 13 years ago
    by Eric Chen
  • Answered

    TMS320C6678 DDR3 PLL Multiplier value 0 Locked

    314 views
    2 replies
    Latest over 13 years ago
    by maril
  • Answered

    Disabling OMAPL138 UART CTS? 0 Locked

    328 views
    3 replies
    Latest over 13 years ago
    by John Wilkes
  • Not Answered

    problem in working OLED display on EKK LM3S6965 0 Locked

    206 views
    1 reply
    Latest over 13 years ago
    by JohnS
  • Answered

    L137 SPI Master Drivers 0 Locked

    341 views
    7 replies
    Latest over 13 years ago
    by Keith Bartels
  • Answered

    measuring time - DSP 674 0 Locked

    363 views
    4 replies
    Latest over 13 years ago
    by Alla
  • Not Answered

    Info required for Overclocking 814x 0 Locked

    314 views
    4 replies
    Latest over 13 years ago
    by Sudeep Hegde
  • Answered

    DM365 USB D+/D- votage 0 Locked

    986 views
    11 replies
    Latest over 13 years ago
    by senthil kumar69729
  • Not Answered

    about leopard ipnc demo 0 Locked

    273 views
    1 reply
    Latest over 13 years ago
    by kailash negi
  • Not Answered

    I set the frame to 60fps,but the capture_encode demo encode in 30fps,why????? 0 Locked

    197 views
    2 replies
    Latest over 13 years ago
    by feng xiao ming
  • Not Answered

    Overlaying text or graphics on video using saMmapLoopback 0 Locked

    175 views
    0 replies
    Started over 13 years ago
    by Faizan Shukoor
  • Suggested Answer

    DM8148: How to support UART2 in Linux 0 Locked

    359 views
    2 replies
    Latest over 13 years ago
    by Nageswari Srinivasan
<>