TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198121 Discussions
  • Answered

    Interrupt questions for 8148 0 Locked

    419 views
    1 reply
    Latest over 13 years ago
    by Karl Wechsler
  • Answered

    Gpio documentation 0 Locked

    177 views
    1 reply
    Latest over 13 years ago
    by Viet Dinh
  • Answered

    Hawkboard: Where has the layout gone wrong? 0 Locked

    394 views
    7 replies
    Latest over 13 years ago
    by jc-ti
  • Not Answered

    Problem with UART1( ttyS1) of DM365 0 Locked

    344 views
    1 reply
    Latest over 13 years ago
    by Hongfeng Wang
  • Answered

    AM3517 - Use of UART4_TX/RX At Same Time as GPMC 0 Locked

    353 views
    1 reply
    Latest over 13 years ago
    by Michael T
  • Not Answered

    boot fail When NFS mounted filesystem is being used 0 Locked

    2264 views
    11 replies
    Latest over 13 years ago
    by Marko Shink
  • Answered

    How to debug DSP CPU stall? 0 Locked

    581 views
    1 reply
    Latest over 13 years ago
    by Lee Holeva
  • Not Answered

    How to start AM3517 from NandFlash? 0 Locked

    440 views
    5 replies
    Latest over 13 years ago
    by Daren Yeo
  • Answered

    SpiFlashWriter and ARM AIS on OMAPL138 0 Locked

    1394 views
    19 replies
    Latest over 13 years ago
    by bowerymarc
  • Not Answered

    Having trouble enabling options in OS Design using Platform Builder 0 Locked

    254 views
    0 replies
    Started over 13 years ago
    by David Lorek
  • Not Answered

    DSP 6416 RESET 0 Locked

    271 views
    1 reply
    Latest over 13 years ago
    by Bill Taboada
  • Answered

    EVMAM1808 photo? 0 Locked

    344 views
    4 replies
    Latest over 13 years ago
    by Anonymous
  • Discussion

    Silicon Revision 2.1 adds MMC/SD Boot Mode Locked

    579 views
    9 replies
    Latest over 13 years ago
    by jc-ti
  • Answered

    DM8168 DEVOSC_DVDD18 SUPPLY 0 Locked

    102 views
    3 replies
    Latest over 13 years ago
    by Steve Clynes
  • Answered

    PRD_obj takes longer than PRD tick - what happends? Crash/corruption..? 0 Locked

    571 views
    3 replies
    Latest over 13 years ago
    by David Friedland
  • Not Answered

    McBSP question on C6748 0 Locked

    144 views
    0 replies
    Started over 13 years ago
    by Marko S
  • Answered

    difference between .coff and .out 0 Locked

    477 views
    1 reply
    Latest over 13 years ago
    by DanRinkes
  • Not Answered

    OMAP to AM37x migration 0 Locked

    195 views
    0 replies
    Started over 13 years ago
    by Karthik Ram
  • Not Answered

    i2c with DM368 0 Locked

    491 views
    1 reply
    Latest over 13 years ago
    by Hongfeng Wang
  • Not Answered

    How to use USB KEYBOARD on u-boot DM37x 0 Locked

    197 views
    0 replies
    Started over 13 years ago
    by Atul Kumar
<>