Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TDA4VM
Hi All,
The 8 ports on J721E is divided like this
RGMII Ports - 1,3,4,8. QSGMII ports - 2,5,6,7
1. The CPSW mac ports is mapped sequentially with PHY. MAC0->RGMII port1, MAC1->RGMII port3 and so on. Am I correct?
2. If…
Part Number: AM6411
I found a hardware feature on AM64x or AM24x that I want to use in my design. How do I tell if TI provides software support for that feature?
Part Number: TMS320C6678
Hi
How to flash the IBL ( Intermediate Boot loader ) into EEPROM and how to flash the application binary into NOR?
How to boot the IBL + Application binary? on C6678 EVM using CCS 9.3
Part Number: TDA4VM Other Parts Discussed in Thread: INA226 ,
Hi
what is the recommended way to measure power consumption of the device and can I get the power consumption for different components like the deep learning accelerators and the GPU?
…
In below Schematic power sequence, why separate VDDSHV_MMCx(VDDSHV5), but other 3.3V VDDSHVn connect to 3V3_SYS, 1.8V VDDSHV connect to 1V8_IO, if VDDSHV_MMCx(VDDSHV5 is 3.3V or 1.8V, can it connect to 3V3_SYS or 1V8_IO?
Or the design…
Part Number: TDA4VM Hi,
I am trying to build C++ application from j721e but running into build errors. Is there a demo application that shows how to build a C++ application from PDK?
I knew D0 and D1 are configurable as MOSI and MISO, but when in SPI bootmode, which pin of D0 and D1 is MISO and MOSI? is it configurable in SPI boot mode?
