TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] TDA4VM: How to enable power for a module (CAN, ADC, etc..) from remote core firmware?

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM I am using the MCAN examples from the SDK and I am integrating this firmware along with Linux on A72. I see my firmware crashing when configuring the CAN module. How can I resolve the issue?
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: Debugging remote core firmware using CCS

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM I am booting remote cores (R5F) from u-boot which run along side Linux (on A72) in my system. I want to debug the remote core firmware by stepping through the source code and modifying / viewing registers and memory. How can I do this…
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: Segmentation fault while flashing using UNIFLASH

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM Other Parts Discussed in Thread: UNIFLASH I am flashing to OSPI using uniflash and below are my commands: karan@karan:~/Desktop$ sudo ./dslite.sh --mode processors -c /dev/ttyUSB1 -f uart_j721e_evm_flash_programmer_release.tiimage…
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to change peripheral initialization from remote core firmware using board library?

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM I want to initialize some additional peripherals for my custom firmware on R5F and remove some redundant initializations. How do I do this using board library in the SDK?
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: Resolve conflict in resource access between remote core firmware and Linux

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM I am running a custom application on R5F and Linux on A72. When I boot the board, Linux complains that it is not able to initiate some devices. Below is the error I see when booting: How can I resolve this?
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to modify pinmux using Board_init() in board library

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM Other Parts Discussed in Thread: SYSCONFIG Can you provide an example of how to add Pinmux for a peripheral using sysconfig / Pinmux tool from dev.ti.com?
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J721E: How to move function/API to specific section in RTOS?

    Brijesh Jadav
    Brijesh Jadav
    Part Number: PROCESSOR-SDK-J721E Other Parts Discussed in Thread: SYSBIOS Many a times, there is a need to move a function/API to a specific section of the memory map, like internal memory for CPU performance optimization or memory optimization. This…
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] AM5718: TI-RTOS Clock function SWI is executed continuously (C6x core)

    ROBERTO MEJIA
    ROBERTO MEJIA
    Part Number: AM5718 Looking at the posts in the forum, I found the following related post in the MSP low-power microcontroller forum: https://e2e.ti.com/support/microcontrollers/msp-low-power-microcontrollers-group/msp430/f/msp-low-power-microcontroller…
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM57X: Steps to modify DDR/RAM configurations for Custom boards.

    ANUBHAV AKASH
    ANUBHAV AKASH
    Part Number: PROCESSOR-SDK-AM57X Hi Team, Can you guide me step by step for modifying DDR/RAM configurations on AM57x.
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: QNX eMMC boot using SPL / Uboot

    KB
    KB
    Part Number: TDA4VM Can eMMC boot mode, be used to boot to QNX using Uboot/SPL for TDA4VM?
    • Answered
    • over 4 years ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198724 Discussions
  • Not Answered

    about emulation window 0 Locked

    269 views
    2 replies
    Latest over 14 years ago
    by kailash negi
  • Answered

    What is ABM7 series crystal? 0 Locked

    268 views
    2 replies
    Latest over 14 years ago
    by Anonymous
  • Not Answered

    AM3715 PoP Offerings 0 Locked

    272 views
    1 reply
    Latest over 14 years ago
    by BrandonAzbell
  • Not Answered

    Android Froyo Dev Kit - OMAP35X 0 Locked

    258 views
    1 reply
    Latest over 14 years ago
    by Satish Patel
  • Answered

    configuration registers for emac control module in CCS shows difference than in the datasheet 0 Locked

    330 views
    6 replies
    Latest over 14 years ago
    by Mukul Bhatnagar
  • Not Answered

    EVM : NAND Flash and Power estimate 0 Locked

    146 views
    0 replies
    Started over 14 years ago
    by Mahesh Shinde
  • Suggested Answer

    Display Interfacing LVDS to TTL - AM3517 0 Locked

    268 views
    1 reply
    Latest over 14 years ago
    by Steve Clynes
  • Answered

    Can AM3892/4 supports LVDS interface to LCD display? 0 Locked

    381 views
    3 replies
    Latest over 14 years ago
    by Steve Clynes
  • Suggested Answer

    Why do need Power-Supply Sequencing of the TMS320DM6467 0 Locked

    275 views
    1 reply
    Latest over 14 years ago
    by Steve Clynes
  • Not Answered

    Reading from UART port.... 0 Locked

    471 views
    4 replies
    Latest over 14 years ago
    by Saravanakrishnan Krishnamoorthy
  • Not Answered

    I earased flash and write back ubl + u-boot and can't connect target in CCSv3 0 Locked

    419 views
    4 replies
    Latest over 14 years ago
    by Pawel Pyszko
  • Answered

    Initialisation of GPIO in kernel for OMAPL137EVM 0 Locked

    677 views
    9 replies
    Latest over 14 years ago
    by Sasikumar Mayandi
  • Not Answered

    Migrating from 1bit ECC to 4bit ECC with the DM6437 0 Locked

    814 views
    4 replies
    Latest over 14 years ago
    by Varada Bellary
  • Answered

    AM1707, Using both EMIFA and LCD Controller 0 Locked

    264 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Not Answered

    McSAP 0 Locked

    202 views
    3 replies
    Latest over 14 years ago
    by TrudyStetzler
  • Answered

    Question about using ARM in OMAP 0 Locked

    311 views
    4 replies
    Latest over 14 years ago
    by Pawel Pyszko
  • Not Answered

    Some questions about the C66x, Linux and TI's roadmap for high performance DSPs 0 Locked

    835 views
    2 replies
    Latest over 14 years ago
    by Chad Courtney
  • Not Answered

    About DM368 SDOFST register 0 Locked

    190 views
    1 reply
    Latest over 14 years ago
    by Nagabhushana
  • Not Answered

    the omap-l138 nand-writer-03.20.00.14 CAN support K9F5608? I am not sure? 0 Locked

    660 views
    5 replies
    Latest over 14 years ago
    by jc-ti
  • Answered

    Kernel Object View Error 0 Locked

    489 views
    3 replies
    Latest over 14 years ago
    by Chris McCormick
<>