TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197753 Discussions
  • Suggested Answer

    Clarification on TVOUT for DM365 0 Locked

    519 views
    7 replies
    Latest over 14 years ago
    by Sudheesh
  • Answered

    DM368 h263 enc+dec perfomance 0 Locked

    393 views
    3 replies
    Latest over 14 years ago
    by Yashwant Dutt
  • Not Answered

    DM365 as usb webcamera 0 Locked

    286 views
    1 reply
    Latest over 14 years ago
    by Ajay
  • Not Answered

    OMAP-L137 and video? What about pinout? 0 Locked

    282 views
    2 replies
    Latest over 14 years ago
    by Gaurav Agarwal
  • Answered

    Application providing the VUI parameters 0 Locked

    343 views
    1 reply
    Latest over 14 years ago
    by Yashwant Dutt
  • Answered

    undefined reference.. while building dm365 h264dec package 0 Locked

    486 views
    8 replies
    Latest over 14 years ago
    by Ashwani
  • Answered

    Using Windows Media Player to play a video stream encoded by DM355 MP4V CODEC 0 Locked

    644 views
    1 reply
    Latest over 14 years ago
    by csghone
  • Not Answered

    Looking for Turbo code encoder / decoder for C55x DSP 0 Locked

    251 views
    0 replies
    Started over 14 years ago
    by Brad S.
  • Suggested Answer

    GigE on OMAPL138 using additional chips 0 Locked

    263 views
    1 reply
    Latest over 14 years ago
    by Bernie Thompson TI
  • Not Answered

    DM365 HDMi input and output 0 Locked

    1014 views
    4 replies
    Latest over 14 years ago
    by Steve Clynes
  • Discussion

    about usb wifi speed on dm355 evm. Locked

    407 views
    5 replies
    Latest over 14 years ago
    by howy
  • Not Answered

    OMAP CCS ctartup code interrupt table 0 Locked

    176 views
    0 replies
    Started over 14 years ago
    by Andry Nikitenko
  • Answered

    PVRTexTool for WinCE 0 Locked

    686 views
    6 replies
    Latest over 14 years ago
    by Tak Izaki
  • Not Answered

    What's the max frequency supported for GPT[8..11]_EVENT_CAPTURE? 0 Locked

    614 views
    3 replies
    Latest over 14 years ago
    by kshin
  • Not Answered

    How to Interface AM1808 with Cyclone4 FPGA? 0 Locked

    387 views
    3 replies
    Latest over 14 years ago
    by Gaurav Agarwal
  • Not Answered

    DIO Library 1.1.0: C6472 - are dbells and LSU interrupts atomic? 0 Locked

    682 views
    9 replies
    Latest over 14 years ago
    by tscheck
  • Answered

    CCSv4 Disabling raw logs LM_tick, LM_post, LM_begin, etc..... 0 Locked

    1084 views
    11 replies
    Latest over 14 years ago
    by Eddie3909
  • Not Answered

    AM35xx Pin Muxing and Types 0 Locked

    418 views
    1 reply
    Latest over 14 years ago
    by Michael T
  • Not Answered

    Can't install xdctools, cgt or bios on Linux 0 Locked

    260 views
    3 replies
    Latest over 14 years ago
    by Ronald Cotton
  • Not Answered

    Won't boot from NAND flash at cold temp 0 Locked

    522 views
    4 replies
    Latest over 14 years ago
    by Jared7
<>