TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198108 Discussions
  • Not Answered

    DSP bridge OMAP3530 Android Froyo not working 0 Locked

    391 views
    2 replies
    Latest over 14 years ago
    by Mitnick
  • Not Answered

    SPI Code Samples 0 Locked

    308 views
    3 replies
    Latest over 14 years ago
    by PaulM
  • Not Answered

    How to recompile codec_engine_xy_y_x libraries? 0 Locked

    106 views
    0 replies
    Started over 14 years ago
    by FabF
  • Not Answered

    Question on YCrCb Demultiplexing for DM6437 0 Locked

    199 views
    0 replies
    Started over 14 years ago
    by Cheah Hun Oon
  • Answered

    Loading Program into 6713B 0 Locked

    356 views
    2 replies
    Latest over 14 years ago
    by Bilal Goraya
  • Answered

    error creating SIO stream 0 Locked

    2900 views
    20 replies
    Latest over 14 years ago
    by Royke
  • Not Answered

    EVM6467T steady "sub-framing" (12 fps) when encoding PAL@50hz 0 Locked

    332 views
    0 replies
    Started over 14 years ago
    by natxominambres
  • Discussion

    DM365 hangs up when video stream has missing frames Locked

    1740 views
    12 replies
    Latest over 14 years ago
    by Jun Yang64790
  • Answered

    Please help connect codec dots 0 Locked

    3624 views
    27 replies
    Latest over 14 years ago
    by Helmut Forren
  • Discussion

    Configuring up a custom 6455 DSP board with CCS 3.3 Setup Locked

    593 views
    5 replies
    Latest over 14 years ago
    by simon blak
  • Not Answered

    AM389x Linux support 0 Locked

    213 views
    1 reply
    Latest over 14 years ago
    by Velan
  • Not Answered

    EMAC transmit problems 0 Locked

    318 views
    3 replies
    Latest over 14 years ago
    by Srirama Govindarajan
  • Answered

    6727-audio initialization and configuration example code 0 Locked

    322 views
    3 replies
    Latest over 14 years ago
    by Ankit Agrawal
  • Not Answered

    Resize and DDR2 bandwidth Problem. 0 Locked

    288 views
    3 replies
    Latest over 14 years ago
    by WeiJiang
  • Not Answered

    byteGenerated 0 Locked

    120 views
    0 replies
    Started over 14 years ago
    by meng zhou
  • Not Answered

    mount nfs fs type error 0 Locked

    294 views
    0 replies
    Started over 14 years ago
    by everest zhang
  • Answered

    MLC NAND for DM365 0 Locked

    428 views
    4 replies
    Latest over 14 years ago
    by cwchang
  • Not Answered

    OMAP L138: few questions to clarify on USB 2.0 controller 0 Locked

    251 views
    0 replies
    Started over 14 years ago
    by Kiung Chung Wong
  • Not Answered

    Linux PPP in omapl137 0 Locked

    675 views
    1 reply
    Latest over 14 years ago
    by Sudhakar Rajashekhara
  • Not Answered

    How to use the eglCreatePixmapSurface function with Windows CE 6 and the OMAP 3530. 0 Locked

    1141 views
    0 replies
    Started over 14 years ago
    by David Paul Robinson
<>