TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198116 Discussions
  • Not Answered

    Issue with ubl AIS file creation - DM6467T 0 Locked

    420 views
    1 reply
    Latest over 14 years ago
    by K Md Feroz Irfan
  • Not Answered

    DM355 CCDC data routing to iPipe 0 Locked

    589 views
    4 replies
    Latest over 14 years ago
    by JPM
  • Answered

    Help on AM35xx flash utility support 0 Locked

    274 views
    1 reply
    Latest over 14 years ago
    by Mugen
  • Not Answered

    DM6467 VPIF: EAV/SAV should be on Y or C in 16-bit input mode 0 Locked

    258 views
    1 reply
    Latest over 14 years ago
    by Manjunath Hadli56783
  • Answered

    Network quit working on DM6467T EVM 0 Locked

    904 views
    6 replies
    Latest over 14 years ago
    by Helmut Forren
  • Not Answered

    DM3730 GPGPU support? 0 Locked

    170 views
    1 reply
    Latest over 14 years ago
    by Sanjeev Premi
  • Not Answered

    valgrind DM644/armle 0 Locked

    258 views
    0 replies
    Started over 14 years ago
    by vijay viswanathan
  • Not Answered

    DM365: interrupt but no output from resizer 0 Locked

    215 views
    0 replies
    Started over 14 years ago
    by Michael Economides
  • Not Answered

    IVA 3 graphics accelerator 0 Locked

    591 views
    1 reply
    Latest over 14 years ago
    by Prabindh Sundareson
  • Not Answered

    Help with device selection for video application 0 Locked

    302 views
    2 replies
    Latest over 14 years ago
    by srirami
  • Not Answered

    Gstreamer on Overo 0 Locked

    256 views
    0 replies
    Started over 14 years ago
    by Rasha
  • Suggested Answer

    NDK Winapps 0 Locked

    516 views
    3 replies
    Latest over 14 years ago
    by Peter Sommerfeld63615
  • Suggested Answer

    OMAPL137 0 Locked

    185 views
    2 replies
    Latest over 14 years ago
    by David Meixner
  • Not Answered

    Video Devices in omap_vout.c 0 Locked

    200 views
    0 replies
    Started over 14 years ago
    by Henry Chan
  • Discussion

    Breakout board for OMAP3530 EVM? Locked

    143 views
    0 replies
    Started over 14 years ago
    by Michael Schwab
  • Answered

    DM365 PRTCSS in external reset mode 0 Locked

    353 views
    3 replies
    Latest over 14 years ago
    by Marcus Cooksey
  • Not Answered

    Booting the C6747 DSP in Slave or Master mode? 0 Locked

    222 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Discussion

    BSP_WINCE_ARM9 01.00.02 Is Now Available For Download Locked

    205 views
    0 replies
    Started over 14 years ago
    by Gary Tominovich
  • Not Answered

    OMAP3515 with 512MB of SDRAM support 0 Locked

    531 views
    4 replies
    Latest over 14 years ago
    by philip lee46717
  • Discussion

    Microsoft Confirms ARM Support for Windows Locked

    178 views
    1 reply
    Latest over 14 years ago
    by asad1
<>