TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197793 Discussions
  • Not Answered

    Floating point vs Fixed point libraries 0 Locked

    310 views
    1 reply
    Latest over 14 years ago
    by Gaurav Agarwal
  • Not Answered

    Code Area unlock or remove protection 0 Locked

    406 views
    7 replies
    Latest over 14 years ago
    by microt
  • Answered

    SRIO - please explain the CBA_TRANS_PRI bits 0 Locked

    271 views
    1 reply
    Latest over 14 years ago
    by tscheck
  • Not Answered

    SRIO and EDMA 0 Locked

    282 views
    1 reply
    Latest over 14 years ago
    by tscheck
  • Discussion

    emmc 4.4 @ wince 6.0 ? Locked

    636 views
    2 replies
    Latest over 14 years ago
    by hb chen
  • Not Answered

    DVSDK 4.0 'make linux' fails 0 Locked

    183 views
    0 replies
    Started over 14 years ago
    by tcalef
  • Suggested Answer

    DM648 PCI Master Write Fifo Problem 0 Locked

    869 views
    14 replies
    Latest over 14 years ago
    by ToddHiers
  • Not Answered

    logic pd omapl138 i2c driver problem 0 Locked

    371 views
    4 replies
    Latest over 14 years ago
    by Army Tsao
  • Answered

    ACPY3_Wait takes long with two video channels on DM648 0 Locked

    1268 views
    15 replies
    Latest over 14 years ago
    by Geoff
  • Answered

    OMAP-L138 - programming Timer 2 and 3 0 Locked

    1794 views
    5 replies
    Latest over 14 years ago
    by clam
  • Not Answered

    TMS320C5505 vs TMS320VC5505 bootloader 0 Locked

    304 views
    3 replies
    Latest over 14 years ago
    by Ming Wei
  • Answered

    USB DMA reading garbage in specific situation 0 Locked

    431 views
    4 replies
    Latest over 14 years ago
    by hunt0r
  • Answered

    DM365: can video digital output comes simultaneously with analog output? 0 Locked

    238 views
    2 replies
    Latest over 14 years ago
    by Paul.Yin
  • Not Answered

    Interesting problem with 1Gbit, NDK2.0, UDP send, DM648 0 Locked

    435 views
    3 replies
    Latest over 14 years ago
    by Steve15
  • Not Answered

    DNS Service Discovery 0 Locked

    154 views
    0 replies
    Started over 14 years ago
    by ARM3035
  • Answered

    C6A8168 's temperature is very high, is it suitable for handhold device? 0 Locked

    319 views
    7 replies
    Latest over 14 years ago
    by Qiang Lee
  • Answered

    Interrupt behavior of DSPLIB functions 0 Locked

    425 views
    2 replies
    Latest over 14 years ago
    by Eric6868
  • Not Answered

    Camera Interface 0 Locked

    231 views
    0 replies
    Started over 14 years ago
    by Ron Pulvermacher
  • Not Answered

    Camera interface 0 Locked

    228 views
    1 reply
    Latest over 14 years ago
    by Andy Neil
  • Not Answered

    About the Image Processing on DM355 0 Locked

    1804 views
    17 replies
    Latest over 14 years ago
    by magda
<>