TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198113 Discussions
  • Not Answered

    about I2C driver of dm355 evm 0 Locked

    306 views
    3 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    open UART of dm355 evm 0 Locked

    208 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    720P HD video supported on DM6437 EVM ? 0 Locked

    930 views
    11 replies
    Latest over 16 years ago
    by RobbySun
  • Not Answered

    H.264 Encoder for OMAP35X 0 Locked

    195 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    OMAP3530/25/15/03 and PMIC clock specifications 0 Locked

    310 views
    0 replies
    Started over 16 years ago
    by A. Musah
  • Answered

    need XDCtools 3.10.04 0 Locked

    479 views
    3 replies
    Latest over 16 years ago
    by Dirk Helgemo
  • Answered

    genAIS utility 0 Locked

    375 views
    3 replies
    Latest over 16 years ago
    by TimHarron
  • Not Answered

    Decode Error: Failed to initialize msp430lib. 0 Locked

    264 views
    0 replies
    Started over 16 years ago
    by white davinci
  • Answered

    DM6446 Modules and Decode demo issues 0 Locked

    334 views
    2 replies
    Latest over 16 years ago
    by Wiley Black
  • Not Answered

    [OMAP3530] 128 Mb Micron NAND Flash 0 Locked

    457 views
    1 reply
    Latest over 16 years ago
    by Subhasish Ghosh
  • Not Answered

    PCB Layout Guidelines for OMAP3530 - CBC package 0.5mm Pitch 0 Locked

    321 views
    0 replies
    Started over 16 years ago
    by Howard Robson
  • Not Answered

    Beginning with OMAP-L137 0 Locked

    1197 views
    14 replies
    Latest over 16 years ago
    by Ted Michon
  • Not Answered

    Audio examples for TMS320C6747 Starter Kit? 0 Locked

    1956 views
    19 replies
    Latest over 16 years ago
    by Mariana
  • Suggested Answer

    [OMAP3530] Using EDMA for transfers between DSP Internal Mem and CMEM in Codec Engine Framework 0 Locked

    403 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Answered

    NFS doent work with EVM SDK 1.0.2 and DVSDK 0 Locked

    1177 views
    11 replies
    Latest over 16 years ago
    by Nishanth Menon
  • Answered

    question about dm643x ccdc hd/vd polarity configuration 0 Locked

    480 views
    4 replies
    Latest over 16 years ago
    by Sivaraj R3681
  • Not Answered

    DM648 decoder codecs error recovery, resilience, tolerance, concealment (TI provided codecs only) 0 Locked

    307 views
    0 replies
    Started over 16 years ago
    by d1234
  • Not Answered

    Dm648 and NDK 0 Locked

    194 views
    0 replies
    Started over 16 years ago
    by Amna Rasul
  • Not Answered

    DM355 PinMux2, EM_A[13:3] vs GPIO[67:57] access 0 Locked

    178 views
    0 replies
    Started over 16 years ago
    by RichardTiller
  • Answered

    cl6x template example link error 0 Locked

    386 views
    2 replies
    Latest over 16 years ago
    by David Hardwick
<>