TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198337 Discussions
  • Not Answered

    OMAP 3430 Camera Interface drivers 0 Locked

    404 views
    2 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    uboot cann't boot from nfs, i am getting crazy. who can help me ? thanks advance Locked

    829 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    How to allocate several different size continuous memory for DSP size ? 0 Locked

    401 views
    3 replies
    Latest over 16 years ago
    by KAKA
  • Discussion

    Davinci Digital Video Locked

    309 views
    3 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    where is the demo code be place? and how does it start when power the EVM? 0 Locked

    380 views
    2 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    USB Locked

    277 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    problem with DSK6455/EVM6455 and CCS 3.3 0 Locked

    502 views
    5 replies
    Latest over 16 years ago
    by TimHarron
  • Discussion

    warm start during idle task execution Locked

    354 views
    1 reply
    Latest over 16 years ago
    by chaitanya kumar B
  • Answered

    [C6713] Interrupt handelling 0 Locked

    1712 views
    11 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    [solved]Problem Using OSD Window 0 and Video Window 0 0 Locked

    361 views
    3 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    Link to DVSDK for OMAP3530 broken Locked

    228 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Migration - NOR Memory to NAND Memory on EVMDM6437 Locked

    532 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Answered

    TMS320C6727B : EMIF bus utilisation with three devices connected 0 Locked

    612 views
    3 replies
    Latest over 16 years ago
    by TimHarron
  • Not Answered

    [solved]VPBE Driver Usage Example -Confusion&Questions about image formats and sizes 0 Locked

    720 views
    5 replies
    Latest over 16 years ago
    by Elric
  • Discussion

    Configuring DDR Memory on DM6437 Locked

    470 views
    2 replies
    Latest over 16 years ago
    by Denis (SYSC)
  • Discussion

    regd. multiple DMA transfers on DM6446 Locked

    452 views
    4 replies
    Latest over 16 years ago
    by Brad Griffis
  • Not Answered

    regd. stall cycles on C64x+ core in DM6446 0 Locked

    263 views
    2 replies
    Latest over 16 years ago
    by vj5712
  • Not Answered

    trying start FVID commands for DM6437 0 Locked

    1040 views
    11 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    XDS560R Code Composer does not support the connected target 0 Locked

    1134 views
    9 replies
    Latest over 16 years ago
    by Mark20
  • Discussion

    Problem Building a New Kernel (4.5) Locked

    568 views
    2 replies
    Latest over 16 years ago
    by Ioan
<>