TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198287 Discussions
  • Not Answered

    OMAP Interface w/ External DAC 0 Locked

    147 views
    0 replies
    Started over 13 years ago
    by George Ioakimedes
  • Not Answered

    AM335x DDR interface is not used, how to connect pins? 0 Locked

    235 views
    0 replies
    Started over 13 years ago
    by Stephanie Goedecke
  • Not Answered

    DM814x-EVM and a new (different) LCD 0 Locked

    528 views
    2 replies
    Latest over 13 years ago
    by Nicholas
  • Not Answered

    Porting IPNC 2.0 release onto 256MB DDR3 custom board 0 Locked

    282 views
    2 replies
    Latest over 13 years ago
    by Karsten
  • Answered

    TEST TMS320C6678LE EVM Devices 0 Locked

    472 views
    4 replies
    Latest over 13 years ago
    by Uday
  • Not Answered

    Ethernet not working after link has been down 0 Locked

    856 views
    5 replies
    Latest over 13 years ago
    by Derek Brown
  • Answered

    dsp/bios 0 Locked

    289 views
    2 replies
    Latest over 13 years ago
    by luo zirong
  • Answered

    1000Mbps on DM8127 IPNC,delay in UI 0 Locked

    668 views
    8 replies
    Latest over 13 years ago
    by Karsten
  • Not Answered

    How to apply samsung nandflash in dm6437 board?? 0 Locked

    200 views
    1 reply
    Latest over 13 years ago
    by Viet Dinh
  • Not Answered

    Add on card with NAND flash 0 Locked

    269 views
    3 replies
    Latest over 13 years ago
    by Michael T
  • Not Answered

    EVM OMAP l-137: Attempt at integrating BIOUSB HostHID and HostMSC 0 Locked

    224 views
    0 replies
    Started over 13 years ago
    by Michael Grant99723
  • Not Answered

    EZSDK release for DM816x/DM814x 0 Locked

    199 views
    1 reply
    Latest over 13 years ago
    by Mohammad Kiaei
  • Not Answered

    AM3505 interface to Micron PSRAM issue 0 Locked

    285 views
    0 replies
    Started over 13 years ago
    by Liju Mathew
  • Answered

    HWI error 0 Locked

    577 views
    7 replies
    Latest over 13 years ago
    by Brian Lacy
  • Answered

    AES Decryption on DM814x / DM81xx 0 Locked

    757 views
    3 replies
    Latest over 13 years ago
    by Herman Schuurman
  • Answered

    for voip application - do I need to install sys/bios 6? 0 Locked

    385 views
    5 replies
    Latest over 13 years ago
    by Karl Wechsler
  • Not Answered

    Unable to get raw frames bigger than 1280x720 from LI-5M03 on TMS320DM365 0 Locked

    727 views
    0 replies
    Started over 13 years ago
    by salvatore benedetto
  • Not Answered

    Where are the McBSP, uPP and EMIFA drivers for the C674x of OMAP-L138 ? 0 Locked

    260 views
    0 replies
    Started over 13 years ago
    by Eric LOUVEL
  • Answered

    How to change meory layout for SysBios v6 0 Locked

    501 views
    4 replies
    Latest over 13 years ago
    by Karl Wechsler
  • Not Answered

    boot Image utility file for TMS320C5535 0 Locked

    386 views
    3 replies
    Latest over 13 years ago
    by Steve Tsang
<>