Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] PROCESSOR-SDK-DRA8X-TDA4X: [PSDKRA]Can I use QT & wayland to render VisionApp result?

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X Hello Could you guide how to use QT & wayland in VissionApp? Thanks in advance, Wilson.

  • [FAQ] DRA829V/TDA4VM: How can I check if cache is enabled or not for R5F

    Part Number: TDA4VM DRA829V Other Parts Discussed in Thread: SYSBIOS I want to check if R5F's Instruction and Data Cache is enabled or not. Attaching the System Register. Please help me check if I can get the above information from the System Registers…

  • [FAQ] PROCESSOR-SDK-DRA8X-TDA4X: How to enable vout1/DPI1 output in vision apps?

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X The vision apps, by default, supports outputs in DPI0/vout0 output port. This article explains how it can be changed to output on DPI1/vout1 output port.

  • [FAQ] CCS/TDA4VM: TDA4VM: How to get Console traces on Lauterbach/Trace32 using DCC?

    Part Number: TDA4VM Other Parts Discussed in Thread: DRA829 Tool/software: Code Composer Studio I do not have any UART instances. How can i get the u-boot console logs on DCC(Debug Communication Channel) using Lauterbach/Trace32?

  • [FAQ] How to flip images on TDA2x/TDA3x/TDA4x?

    This article explains different ways in which images can be flipped on TDA devices.

  • [FAQ] TDA4VM: How to resolve Yocto build failure while trying to fetch repository?

    Part Number: TDA4VM Is there a checklist for addressing fetch failures while building with Yocto?

  • [FAQ] CCS/TDA4VM: TDA4: How do I determine the GPIO number within linux for a pin within the schematic?

    Part Number: TDA4VM Tool/software: Code Composer Studio I have a bunch of pins that i want to configure as GPIO and use them in Linux. How do i determine which Linux GPIO numbers corresponding to those pins in the schematic?

  • [FAQ] TDA2SX: How do I configure the H.264 Encoder Constant Bit Rate (CBR) and Variable Bit Rate (VBR) on IVAHD?

    Part Number: TDA2SX I have read from the user guide that the IVAHD encoder supports this feature, can you share the steps for the same.

  • [FAQ] TMS320C6678: How do I enable jumbo packet support on C6678?

    Part Number: TMS320C6678 The default NDK/NIMU example only supports regular Ethernet packet (1514 bytes). The article describes how to enable NDK/NIMU driver and test for the jumbo packet support on TI C6678 device. When enabling/testing for other TI…

  • [FAQ] CCS/TDA4VM: How to use SPI/SPI_DEV on TDA4/J721E?

    Part Number: TDA4VM Tool/software: Code Composer Studio I have the following questions on TDA4VM SPI: How to enable SPI instances of TDA4VM? How to enable SPIDEV on TD4VM SDK? How to exercise from user space the TI J7/TDA4x SPI interface?

View FAQ threads
  • Threads 197921 Discussions