Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Hello,
Here is a quick look at live demonstrations on TI's Edge AI Platform shown at Embedded World 2022 .
These examples can be easily recreated on TI’s devices, please see the table below for links to relevant Software and Hardware modules. Setup…
Part Number: 66AK2H12 Hi,
How to flash the SBL ( Secondary Boot loader ) into NOR and how to flash the application binary into NOR? How to boot the SBL + Application binary? on K2H board.
Part Number: AM625
Hi experts
I have some problems about AM6254 mmc part
1. Is it feasible to use the second MMC interface (MMC2) of TI's AM6254x as the boot of the SD card? Because this group of SDCD&SDWP and other data lines are together and can…
Part Number: TDA4VM
Hi Gang,
I'm doing distortion correction on TDA4 using DCC tool, and I have found your workflow instruction: https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1058565/faq-tda4vm-how-to-create-a-ldc-mesh…
Part Number: 66AK2E05 Other Parts Discussed in Thread: SYSBIOS , CCSTUDIO ,
Hi,
Would you please provide a "Quick start Guide for K2E - EVM " to enable a quick product development ?
Part Number: TDA4VM The Linux based SRV application on TDA4VM takes 20-25 Seconds to launch based on the boot media and the media hosting the rootfs. How to optimize this to 2-3 seconds?
