Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625 Other Parts Discussed in Thread: AM62L
Tool/software:
Hi TI Experts,
I see some of the processor pins named RSVD or RSVD0
Are there some recommendations to be followed during custom board design.
Note:
The FAQ is valid…
Part Number: AM625 Other Parts Discussed in Thread: AM6442 , , AM62P , SYSCONFIG
Tool/software:
Hi TI Experts,
I have a question about "Figure 7-16. MCU_OSC0 Start-up Time" from the datasheet. Here it looks like that MCU_OSC0 is only allowed to…
Part Number: AM3357
Tool/software:
Hi team,
I am planning to input an analog signal to AM3357's AIN by dividing the voltage. Was the constant of the voltage divider resistor OK with the constant shown in the figure? I am wondering if I should add…
Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
Questions addressed in this post:
What is OSPI Phy Tuning?
When is the Phy Tuning Algorithm used?
Where is the Phy enabled and disabled throughout the MCU PLUS SDK…
Part Number: AM6442 Other Parts Discussed in Thread: SK-AM64B
Tool/software:
Hello,
I am designing a board with Ethernet and USB3 using the AM6442. I have referred to the device sheet and TRM, but I could not find the required specifications for…
Part Number: AM6442
Tool/software:
Dear Sitara HW champs,
In the Table “6-19. MCU_OSC0 Crystal Circuit Requirements” in the AM64x datasheet, it is specified the following :
. When not using the RGMII and/or RMII interfaces, then +/-100 ppm Xtal…
Part Number: PROCESSOR-SDK-AM64X Tool/software: I am trying to load the SDK example code to AM62x/AM64x board, but I am facing an issue while loading the program into it as shown in the below screenshot.
Can you please help to resolve the above error…
