TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198113 Discussions
  • Not Answered

    Smart Reflex Testing using boundary scan control 0 Locked

    571 views
    8 replies
    Latest over 12 years ago
    by Tom Johnson 16214
  • Not Answered

    Program using BIOS6 for 6678 0 Locked

    275 views
    3 replies
    Latest over 12 years ago
    by Johannes
  • Answered

    DDR_VREF reference for decoupling signal 0 Locked

    381 views
    1 reply
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Answered

    Interrupt the other core after EDMA transfer 0 Locked

    358 views
    3 replies
    Latest over 12 years ago
    by HRi
  • Answered

    Where is the file $kernel_source/arch/arm/mach-omap2/ti81xx_fb.c? 0 Locked

    405 views
    2 replies
    Latest over 12 years ago
    by Vladimir-XID
  • Not Answered

    DDR2 Clock Jitter 0 Locked

    1206 views
    5 replies
    Latest over 12 years ago
    by AnBer
  • Answered

    Problem with HDMI output on Blaze board 0 Locked

    180 views
    1 reply
    Latest over 12 years ago
    by Manuel Contreras
  • Answered

    Change IPC's notify setup delegates in Codec Engine 0 Locked

    782 views
    5 replies
    Latest over 12 years ago
    by Vincent W.
  • Answered

    Task_sleep consuming more CPU than expected 0 Locked

    327 views
    3 replies
    Latest over 12 years ago
    by Alan DeMars
  • Not Answered

    DM8107 SERDES Clock Input 0 Locked

    461 views
    1 reply
    Latest over 12 years ago
    by K Md Feroz Irfan
  • Answered

    Support for AM3359 in TI-RTOS? 0 Locked

    260 views
    2 replies
    Latest over 12 years ago
    by John Conover
  • Answered

    How to test the performance of MJPEG encoder of YUV422I 0 Locked

    1640 views
    5 replies
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    DVR device 0 Locked

    1148 views
    10 replies
    Latest over 12 years ago
    by Luca Ruffini
  • Not Answered

    Configuring VPSS in 16-bit mode in DVR-RDK 0 Locked

    252 views
    1 reply
    Latest over 12 years ago
    by Sujith
  • Not Answered

    AM335X JTAG 0 Locked

    1817 views
    1 reply
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Answered

    AM1705: The same code works when loaded with JTAG from CCS and does not work when loaded in sft 0 Locked

    277 views
    1 reply
    Latest over 12 years ago
    by Shankari G
  • Answered

    AM3359ICE - TI_ECAT.patch file patch failed 0 Locked

    393 views
    2 replies
    Latest over 12 years ago
    by LUO SYSH-SHIVAN
  • Not Answered

    stability of ext2 file system on SD Card 0 Locked

    3302 views
    4 replies
    Latest over 12 years ago
    by Francis Kumar
  • Not Answered

    Interfacing CC2520 with C5505 ezDSP stick 0 Locked

    229 views
    0 replies
    Started over 12 years ago
    by qwerty asdfgh
  • Not Answered

    SRIO - proper interface 0 Locked

    327 views
    2 replies
    Latest over 12 years ago
    by Jiri Macola
<>