TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198147 Discussions
  • Answered

    C5505 booting via USB 0 Locked

    424 views
    1 reply
    Latest over 13 years ago
    by Greg Basile57785
  • Not Answered

    C542 DSP Library FFT Wonky 0 Locked

    270 views
    0 replies
    Started over 13 years ago
    by Micah Dombrowski
  • Not Answered

    BDEC register behaviour 0 Locked

    196 views
    1 reply
    Latest over 13 years ago
    by Chad Courtney
  • Discussion

    Renaming readwrite.out Locked

    243 views
    3 replies
    Latest over 13 years ago
    by Steven Connell
  • Answered

    tms320c5515 fdk 0 Locked

    175 views
    1 reply
    Latest over 13 years ago
    by Mark M
  • Not Answered

    AM35x Suspend wakeup problem 0 Locked

    443 views
    1 reply
    Latest over 13 years ago
    by Matteo Geromin
  • Answered

    C6678 SRIO Driver 0 Locked

    2438 views
    9 replies
    Latest over 13 years ago
    by Karthik Ramana Sankar
  • Answered

    load 2nd stage u-boot.bin over uart not sending 0 Locked

    289 views
    1 reply
    Latest over 13 years ago
    by Pavel Botev
  • Not Answered

    booting from spi flash 0 Locked

    231 views
    3 replies
    Latest over 13 years ago
    by K Md Feroz Irfan
  • Answered

    AM1705_Custom Board - CRC error during UART Boot 0 Locked

    462 views
    5 replies
    Latest over 13 years ago
    by Mahesh Mokal
  • Not Answered

    early change default pullup pulldown PUPD_SEL settings in OMAP L138/ find pin group information 0 Locked

    1588 views
    2 replies
    Latest over 13 years ago
    by Bastian
  • Not Answered

    Significance of '0x11F00700' memory location for Boot Process 0 Locked

    328 views
    6 replies
    Latest over 13 years ago
    by Mukul Bhatnagar
  • Answered

    Please help resolve "Instruction fetch exception" 0 Locked

    439 views
    1 reply
    Latest over 13 years ago
    by Robert Tivy
  • Not Answered

    Configuring CS7 of the OMAP 0 Locked

    736 views
    7 replies
    Latest over 13 years ago
    by hrishikesh choudhary
  • Answered

    Code crashing with message instruction fetch exception 0 Locked

    1454 views
    1 reply
    Latest over 13 years ago
    by Robert Tivy
  • Answered

    MessageQ_count fails..please help 0 Locked

    419 views
    2 replies
    Latest over 13 years ago
    by RCReddy
  • Answered

    Is MSGQ_alloc required for inner processor MSGQ usage? 0 Locked

    367 views
    2 replies
    Latest over 13 years ago
    by Alen Cruz
  • Discussion

    Fixing ^C and error "can't access tty; job control turned off" in busybox Locked

    1501 views
    1 reply
    Latest over 13 years ago
    by Graham Newton
  • Not Answered

    GDB debugging double free: corrupted stack? 0 Locked

    2517 views
    0 replies
    Started over 13 years ago
    by Qmax
  • Not Answered

    How to speed up GPIO access on the DM8168? 0 Locked

    480 views
    2 replies
    Latest over 13 years ago
    by Julie Lambert
<>