TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198359 Discussions
  • Discussion

    Re: ARM Privilege Mode-OMAPl138 code hangs Locked

    220 views
    2 replies
    Latest over 14 years ago
    by vijayabharathi chelladurai
  • Not Answered

    DM368 Layout help 0 Locked

    187 views
    0 replies
    Started over 14 years ago
    by Pini Sberro
  • Not Answered

    TMS320C6746 Frequency Scaling, Power Consumption and Management 0 Locked

    441 views
    0 replies
    Started over 14 years ago
    by Scott Burton
  • Answered

    C6745/47 EMIFB Supported SDRAM 0 Locked

    224 views
    1 reply
    Latest over 14 years ago
    by Tai Nguyen
  • Not Answered

    using memory from POOL_alloc 0 Locked

    1027 views
    7 replies
    Latest over 14 years ago
    by Chris Norris
  • Not Answered

    Fail to load DSP when system busy 0 Locked

    252 views
    0 replies
    Started over 14 years ago
    by FabF
  • Not Answered

    The Problem of DVMA2 MJPEG 5MP Capture 0 Locked

    245 views
    1 reply
    Latest over 14 years ago
    by Raghu Kudva
  • Not Answered

    Linux Driver HD-VPSS 0 Locked

    138 views
    0 replies
    Started over 14 years ago
    by RV
  • Answered

    EMIFA Minimum Operating Frequency 0 Locked

    247 views
    2 replies
    Latest over 14 years ago
    by 1258021
  • Not Answered

    Enabling Linux KEXEC via TI processors 0 Locked

    241 views
    0 replies
    Started over 14 years ago
    by Nick Lamb
  • Not Answered

    OMAP3530 McBSP Not Receiving 0 Locked

    221 views
    1 reply
    Latest over 14 years ago
    by Joe Bauman
  • Answered

    posting a SWI inside an IPC function callback 0 Locked

    431 views
    2 replies
    Latest over 14 years ago
    by mohammed maktite
  • Not Answered

    DSPLink 1.65 Test suites 0 Locked

    166 views
    0 replies
    Started over 14 years ago
    by Sachidananda Karanth
  • Not Answered

    AM3505 internal ROM BOOT read nand flash 0 Locked

    270 views
    0 replies
    Started over 14 years ago
    by Jun Feng Xu
  • Answered

    no output of gingerbread on beagle-xm 0 Locked

    370 views
    3 replies
    Latest over 14 years ago
    by Michael Risley
  • Not Answered

    Re: Future Support Audio Codecs (MP3, AAC) on DSP needs clarification 0 Locked

    362 views
    0 replies
    Started over 14 years ago
    by RV
  • Answered

    Windows Embedded Compact 7 omap3530 documentation? 0 Locked

    345 views
    1 reply
    Latest over 14 years ago
    by Atul Verma
  • Not Answered

    2.6.38 kernel for Beagle Board 0 Locked

    233 views
    1 reply
    Latest over 14 years ago
    by Power Pan
  • Not Answered

    how to build a codec on beagleboard dsp 0 Locked

    212 views
    3 replies
    Latest over 14 years ago
    by Maik Pflugradt
  • Answered

    REG: Capture Test application in new released WinCE BSP(Patch 01) 0 Locked

    405 views
    5 replies
    Latest over 14 years ago
    by Gary Tominovich
<>