TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198301 Discussions
  • Answered

    DM365 MPEG4 encode noise at inputWidth>=160 0 Locked

    1218 views
    13 replies
    Latest over 14 years ago
    by Yoichi
  • Not Answered

    C6A8168 Power Requirement 0 Locked

    511 views
    15 replies
    Latest over 14 years ago
    by MarcPyne
  • Not Answered

    Next version of C6A8168 0 Locked

    138 views
    3 replies
    Latest over 14 years ago
    by RandyP
  • Answered

    Where can I find #defines for field and values in rCSL quickstart examples 0 Locked

    325 views
    2 replies
    Latest over 14 years ago
    by MikeH
  • Not Answered

    problem with nand file system 0 Locked

    236 views
    0 replies
    Started over 14 years ago
    by David Johnson71869
  • Not Answered

    video capture problems when test TVP5158 on dm6467 0 Locked

    652 views
    3 replies
    Latest over 14 years ago
    by David Friedland
  • Answered

    How to use IOM packages to develop DM6437 driver? 0 Locked

    432 views
    3 replies
    Latest over 14 years ago
    by David Friedland
  • Not Answered

    ARM Register visibility in CCS4? 0 Locked

    204 views
    0 replies
    Started over 14 years ago
    by MikeH
  • Answered

    Use NDK to send out packet through PHY 0 Locked

    305 views
    1 reply
    Latest over 14 years ago
    by Steven Connell
  • Not Answered

    C5505 RTC Write Access 0 Locked

    231 views
    2 replies
    Latest over 14 years ago
    by Jrvanho
  • Answered

    ARM Register Documentation 0 Locked

    726 views
    3 replies
    Latest over 14 years ago
    by MikeH
  • Answered

    DM365 Questions (power-off & drivers) 0 Locked

    388 views
    7 replies
    Latest over 14 years ago
    by Igor Pototskiy
  • Answered

    SWI argument runtime modification in SYS/BIOS 0 Locked

    1803 views
    2 replies
    Latest over 14 years ago
    by Peter Steinberg
  • Not Answered

    OMAP3530 DSP Access to SOC Peripherals 0 Locked

    335 views
    4 replies
    Latest over 14 years ago
    by SamL
  • Not Answered

    Running filter demo using external power supply 0 Locked

    184 views
    3 replies
    Latest over 14 years ago
    by Hyun Kim
  • Not Answered

    USB module stops working when using bootloader. 0 Locked

    310 views
    5 replies
    Latest over 14 years ago
    by Hyun Kim
  • Not Answered

    Average current consumption of the C5515 DSP vs clock fequency ? 0 Locked

    193 views
    1 reply
    Latest over 14 years ago
    by Hyun Kim
  • Answered

    ARM .asm file not getting linked to project .out file? 0 Locked

    500 views
    3 replies
    Latest over 14 years ago
    by MikeH
  • Answered

    UART Example located in CCS3.3 0 Locked

    264 views
    4 replies
    Latest over 14 years ago
    by Sean Tsai
  • Not Answered

    Needed Changes in UBoot source code in order to boot from 2 SPI flashes 0 Locked

    233 views
    2 replies
    Latest over 14 years ago
    by dabuan
<>