Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP
Tool/software:
Hi, My customer is using SD card boot only for development phase. For production, only QSPI boot is used. QSPI or SD card boot selection is done by DIP switch on the board…
Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
From release 10.00.00.14 onwards, BBM has been implemented in TI Drivers for NAND Flash Parts.
AM62A MCU SDK: https://www.ti.com/tool/download/MCU-PLUS-SDK-AM62A/10.00…
Part Number: TPS62867
Tool/software:
Hi Experts,
Customer is using the below device
The input is 3.6V - 5%
The output is 3.3V + 5%
Current 1-2 A.
Is there a min voltage difference that is required between the output and the input.
Regards…
Part Number: AM625
Tool/software:
HI TI experts,
I have a question on the SOC ROC.
Can i consider the ROC to be ±5% of the Nominal value for the supply rails or should i be considering the values mentioned in the data sheet ( some of the supplies…
Part Number: AM625 Other Parts Discussed in Thread: AM62L
Tool/software:
HI TI experts,
Could you provide recommendations on CAP_VDDSx, cap value and effect of the capacitor not mounted or shorted.
Part Number: PROCESSOR-SDK-AM57X Tool/software: This is a patch to made for U-boot as an example of how to implement the workaround for AM57xx errata i2446:
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1
Tool/software:
Hello,
May I have question about SoC clock?
Q1
In this document,
https://www.ti.com/lit/an/sprad21e/sprad21e.pdf
It says EPHY need match clock to SoC.
Is the…
