TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197747 Discussions
  • Discussion

    Low DDR Memroy bandwidth in 2.6.22 (PSP 1.0.2) Locked

    318 views
    0 replies
    Started over 16 years ago
    by Vijay
  • Answered

    downloading ccs geneted file from ARM using linux(DVSDK) in OMAP3530 0 Locked

    444 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    USB EHCI on 2.6.22 PSP Release. 0 Locked

    248 views
    1 reply
    Latest over 16 years ago
    by Ajay
  • Not Answered

    Problem with Code Composer Studio and printf 0 Locked

    484 views
    8 replies
    Latest over 16 years ago
    by tomeko
  • Discussion

    OMAP3 EHCI USB HS mode performance issue Locked

    227 views
    1 reply
    Latest over 16 years ago
    by Ajay
  • Discussion

    DM6437 Video Capture, Interrupt Handling Locked

    226 views
    0 replies
    Started over 16 years ago
    by Bandeg
  • Discussion

    Two display ports??...HELP! Locked

    412 views
    7 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    best way to allocate RAM vs Cache on DM6437 Locked

    383 views
    3 replies
    Latest over 16 years ago
    by Brad Griffis
  • Discussion

    OMAP2430 and TMS320C6x Locked

    254 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    IPIPE Locked

    225 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    Compiling the serverfile using dm6467 tool chain to run it on dm6446 Locked

    208 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    NDK HTTP server - incorrect Content-Type 0 Locked

    341 views
    3 replies
    Latest over 16 years ago
    by tomeko
  • Discussion

    opt6x/cgtools 6.1.7 seg fault Locked

    214 views
    0 replies
    Started over 16 years ago
    by tomeko
  • Not Answered

    Regarding IMGLIB on video capturing 0 Locked

    386 views
    3 replies
    Latest over 16 years ago
    by Matthew4537
  • Not Answered

    Camera ISP IN OMAP 3530 0 Locked

    326 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    about JPEG decoder issue on DM355 0 Locked

    282 views
    4 replies
    Latest over 16 years ago
    by YHLShareware
  • Discussion

    How to implement Ethernet function with 6431? Where can I find sample code? Locked

    518 views
    7 replies
    Latest over 16 years ago
    by teddy9483
  • Discussion

    OMAP-L137 EVM board design Locked

    312 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Where to Obtain Latest Tool Releases? 0 Locked

    10248 views
    77 replies
    Latest over 16 years ago
    by HyperGalaxy
  • Discussion

    Video decode demo frame rate control? Locked

    448 views
    4 replies
    Latest over 16 years ago
    by RobbySun
<>