Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TDA4VM
Tool/software:
Last Updated : April 1st, 2025
This post is created to track commonly asked questions pertaining to the LPDDR4 interface for TDA4x, DRA8x, AM68x, and AM69x devices. It will be updated as needed.
Supported DDR…
Part Number: TDA4VH-Q1 Tool/software: Why is my LBIST status read by invoking the function 'SDL_LBIST_getPOSTStatus(&postResult)' - SDL_LBIST_POST_NOT_RUN?
Part Number: PROCESSOR-SDK-J722S Tool/software: There is a memory mapping issue in the uboot, which can potentially cause random crash when running vision apps demos on J7AEN device. This FAQ provides fixes for this issue.
Part Number: AM6412
Tool/software:
Hi T.I community expert,
1) There is something which is not clear about MMC0_CLK recommandations:
When looking at the datasheet (2024) table 5-80 one can read the following :
==> MMC0_CLK can be left open…
Part Number: AM62L Other Parts Discussed in Thread: TMDS62LEVM
Tool/software:
Hi Board designers,
AM62L: Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and EVM
Regards,
Sreenivasa
Part Number: AM62L
Tool/software:
Hi TI experts,
I have completed my custom board schematics based on AM62Lx SOC. Could you guide me on reviewing the schematics.
Part Number: AM62L
Tool/software:
Hi TI Experts,
I have the below queries regarding the I2C interface
Need information on the number of I2C interfaces available
Termination of I2C interfaces when used as I2C interface and not used as I2C interface…
Part Number: AM62L
Tool/software:
Hi TI Experts,
I am starting a new board design and planning to use TI EVM design files for designing my custom board. Please let me know if you have any suggestions.