TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198111 Discussions
  • Not Answered

    When the EVM attempts to mount a NFS file system on a Linux host PC, the EVM shows the error 'Root-NFS: Server returned error -13 while mounting /mount/point' 0 Locked

    664 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    General debugging questions on OMAP35x EVM 0 Locked

    433 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    XDS510 supports DM648 or not? Locked

    479 views
    5 replies
    Latest over 16 years ago
    by vcar4195
  • Discussion

    Memory Protection for L1 CACHE Locked

    761 views
    10 replies
    Latest over 17 years ago
    by Amit Kale
  • Discussion

    Where can I find the GEL file to use with DM6467 EVM? Locked

    420 views
    0 replies
    Started over 17 years ago
    by Juan Gonzales
  • Discussion

    c5502: usign HPI.HAS# as GPIO Locked

    397 views
    2 replies
    Latest over 17 years ago
    by sch
  • Not Answered

    Where can I get more information on VLYNQ? 0 Locked

    662 views
    2 replies
    Latest over 17 years ago
    by Brad Griffis
  • Not Answered

    CSL for DM6446 0 Locked

    370 views
    2 replies
    Latest over 17 years ago
    by Juan Gonzales
  • Discussion

    DM648 EDMA quick question.... Locked

    573 views
    2 replies
    Latest over 17 years ago
    by JRasmussen
  • Discussion

    DM6441-dianostic tool to test device functionality Locked

    321 views
    2 replies
    Latest over 17 years ago
    by Bernie Thompson TI
  • Discussion

    OSD questions Locked

    400 views
    4 replies
    Latest over 17 years ago
    by BH4636
  • Discussion

    EDMA3 on DM6446 queries Locked

    354 views
    4 replies
    Latest over 17 years ago
    by Amit Kale
  • Not Answered

    Problem with DMA on Simulator 0 Locked

    626 views
    6 replies
    Latest over 17 years ago
    by william4015
  • Discussion

    Flashburn checksum on DM648 EVM Locked

    403 views
    3 replies
    Latest over 17 years ago
    by chris2476
  • Not Answered

    fopen returning null 0 Locked

    844 views
    2 replies
    Latest over 17 years ago
    by Danneman
  • Discussion

    TMS320DM6446 Silicon Revisions 2.1 Locked

    383 views
    6 replies
    Latest over 17 years ago
    by Marcel5067
  • Not Answered

    Does the TMDXEVM3503 OMAP EVM include DVSDK? 0 Locked

    2393 views
    22 replies
    Latest over 17 years ago
    by Juan Gonzales
  • Discussion

    Issue with DVI output Locked

    940 views
    11 replies
    Latest over 17 years ago
    by Brijesh Jadav80
  • Discussion

    How to use half rate mode on DM6446 to connect to LCDs that require data rate at twice the clock frequency? Locked

    222 views
    0 replies
    Started over 17 years ago
    by Juan Gonzales
  • Discussion

    OMAP35X SGX graphics support Locked

    235 views
    1 reply
    Latest over 17 years ago
    by Bernie Thompson TI
<>