Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask technical support questions on everything from temperature and humidity sensors to magnetic sensors and mmWave sensors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] Illuminated Inductive Touch Buttons

    Other Parts Discussed in Thread: LDC3114-Q1 , LDC2114 , LDC2112 , LDC3114 How would you implement an inductive touch button that needs to be illuminated?

  • [FAQ] TMAG5328: How to support using a resistor adjustable switch (TMAG5328) and a generic switch with the same PCB footprint?

    Part Number: TMAG5328 How to support using a resistor adjustable switch ( TMAG5328 ) and a generic switch with the same PCB footprint?

  • [FAQ] LDC3114: Example Code

    Part Number: LDC3114 Where can I find example code for the LDC3114 or LDC3114-Q1?

  • [FAQ] TMAG5170: Where can I find code examples

    Part Number: TMAG5170 Q: Are code examples available to download for TMAG5170 and TMAG5170-Q1? A: Code demonstrating a variety of functions including common device configurations, device output reads, piecewise linearization calibration, and angle calculations…

  • [FAQ] Factors to consider when setting the baseline tracking algorithm for rapid temperature changes

    Other Parts Discussed in Thread: LDC3114-Q1 , LDC2114 , LDC2112 , LDC3114 What factors need to be considered when setting the baseline increment (NPBI or LPBI) for the LDC2112, LDC2114, LDC3114, or LDC3114-Q1?

  • [FAQ] TMAG5170: How are 3D Hall-effect Sensors used in Robotics?

    Part Number: TMAG5170 Other Parts Discussed in Thread: TMAG5273 Robotic mechanisms require a programmed response to setup and control behavior to accomplish a specific task. These tasks vary from mobile transport to stability controls or manufacturing…

  • [FAQ] TMAG5170: How does magnet selection impact Hall-effect angle measurements?

    Part Number: TMAG5170 Other Parts Discussed in Thread: TMAG5273 The first step when designing for any angle measurement using magnetic inputs (Hall-effect, AMR, GMR, TMR) is to select the magnet to be used as an input source. Depending on the directional…

  • [FAQ] PGA970: How can I access the full datasheet for the PGA900 or the PGA970?

    Part Number: PGA970 Other Parts Discussed in Thread: PGA900 How can I access the full datasheet for the PGA900 or the PGA970?

  • [FAQ] How do I set the IDRIVE register for the LDC1614, LDC1612, LDC1314, or LDC1312?

    Other Parts Discussed in Thread: LDCCOILEVM , LDC1614EVM What factors do I need to consider when setting the LDC161x or LDC131x current drive?

  • [FAQ] DRV5011: What is the difference between using Hall-effect latches for rotary encoding and motor commutation?

    Part Number: DRV5011 On the surface rotary encoding and motor commutation seem very similar because they both involve sensing the position of a rotating magnet and sending that information back to the system. Hall-effect latches can be used for both…

View FAQ threads