Other Parts Discussed in Thread: LSF0101
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters > Current FAQ
In most cases, it is recommended to test with the device EVM instead as it yields much more accurate results under specific…
Part Number: AM2634
Tool/software:
This FAQ will cover following questions:
What is does Pre Integrated stack mean?
What is EtherCAT HW accelerator?
Which part we need to use for standard Ethernet on PRU ICSS
Which part should I use for EthernetIP and…
Part Number: AM62A7 Other Parts Discussed in Thread: AM62P , AM69A , AM68A , AM67 , , AM625 , AM623
Tool/software:
What are the most common problems encountered when developing camera applications on the AM6x (AM62/AM62A/AM62P/AM67/AM68A/AM69A) and what are…
Part Number: AM62A7 Other Parts Discussed in Thread: AM67 ,
Tool/software:
I connected my CSI camera to my board and the sensor has successfully probed, but I'm not able to capture images from the camera. None of "v4l2-ctl --stream-mmap", "yavta -c", or…
Part Number: AM62A7 Other Parts Discussed in Thread: AM62P , , AM67 , AM625 , AM623
Tool/software:
I connected my CSI camera to my board, but the sensor didn't probe. What are the possible reasons the sensor doesn't probe?
Other parts: AM62A3 , , AM62A3…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP
Tool/software:
AM62x boot rom supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM
Tool/software:
Hi Customer,
This FAQ will introduce the detail steps for different SDK in SBL or SPL.
BR,
Biao
Part Number: TPS1H100-Q1
Tool/software:
The H, HB, and HC families of high-side power switch devices implement current limit by the placement of a resistor (R ILIM ) in external circuitry connected to the chip, and the current limit can be adjusted by the…
Part Number: TMUX1308-Q1
Tool/software:
Hi Experts, '
Is there any guidelines to follow regarding the input when the TMUX is not powered.
Can i apply input voltage when the supply is not available.
Thank you for the guidance.
Regards,
Sreenivasa …
Part Number: AM62A7
Tool/software:
I connected a sensor to my AM62A starter kit EVM, and the sensor correctly probed. When I did "v4l2-ctl --list-devices", many "/dev/videoX" nodes were listed. Which one should be used to capture images from the sensor…