Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] LMV358: What is the best cross reference replacements for the LMV321, LMV358, LMV324 op amp devices?

    Part Number: LMV358 Other Parts Discussed in Thread: LMV321 , , LMV324 , , LMV324A , LMV321A , TLV9002 , TLV9004 , TLV9001 , LM2902 , LM2904 , LM2904-Q1 , LM358B , LM358LV , LM358 , LM2904B , LM2904LV , LM2902LV , LM2904B-Q1 , OPA2990 , TLV9064 , TLV9062 , TLV9061 Hi, Are…

  • [FAQ] ISO224: Tying ISO224 OUTN to GND2

    Part Number: ISO224 Other Parts Discussed in Thread: , TLV6001 , OPA277 This might be a silly question, but is there any problem that might arise when tying the negative output of ISO224 to the low-side ground, GND2? My original plan was to do this because…

  • [FAQ] What are the best cross reference replacement for the MCP6001, MCP6002, and MCP6004 devices?

    Other Parts Discussed in Thread: TLV9064 , TLV9004 , TLV9001 , TLV9062 , TLV9061 , TLV9002 Hello, I need to identify replacement op amps for the MCP6001, MCP6002, and MCP6004 devices. What are the best replacement amplifiers from TI? Thanks!

  • [FAQ] LM2904: What are the best op amps for low cost designs?

    Part Number: LM2904 Hello, Could you help with the selection of op amps for low cost or cost-optimized circuit designs? Thanks!

  • [FAQ] Can you tell me the number of transistors in my device for my reliability modeling?

    Sometimes it is useful to know the number of transistors in a part for quality and reliability modeling. How can I get that information from TI?

  • [FAQ] Things to consider with high voltage measurements with op-amps?

    Other Parts Discussed in Thread: ANALOG-ENGINEER-CALC , TLV313 If your circuit has a high voltage measurement circuit, there are many things to consider. Have you considered the effects of temperature? The voltage coffiecient of the resistors?

  • [FAQ] Current Sensors and Power Monitors FAQ Links

    Many postings in the E2E Forum can be designated as a Frequently Asked Question or FAQ. In order for you to quickly create a system and implement a current and power sensing solution here is a curation of links to these FAQ postings. As time goes on more…

  • [FAQ] INA181: Understanding the Output Swing of Current Shunt Monitors and Amplifers

    Part Number: INA181 Other Parts Discussed in Thread: INA199 How to interpret and utilize the output swing specifications of current sense amplifiers so I can get the most out of my current measurements?

  • [FAQ] INA3221: Why are some current sense amplifier defined as high-side when common mode range is down to -0.3V to 26V.

    Part Number: INA3221 Other Parts Discussed in Thread: INA219 , INA226 Why is the INA3221 and INA219 presented as high side devices when there common mode rage is -0.3V - 26V.

  • [FAQ] INA233: How to use the power accumulator

    Part Number: INA233 How to use the power accumulator

View FAQ threads