TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Amplifiers

Amplifiers

Amplifiers forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] INA250: Can I use the INA250 inline with a PWM signal?

    Harsha Munikoti
    Harsha Munikoti
    Part Number: INA250 Other Parts Discussed in Thread: INA240 , INA253 Can I use the INA250 inline with a PWM signal?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA250: Where can I find the user's guide for the INA250EVM with just one A2 device?

    Harsha Munikoti
    Harsha Munikoti
    Other Parts Discussed in Thread: INA250EVM I have a version of the INA250EVM from TI that is different than the one shown on the product page. The board I have has a single INA250A2 unit installed on it. Is there a user's guide for this board?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA210: What is the difference between the INA21xA, INA21xB, and INA21xC devices?

    Manuel Chavez
    Manuel Chavez
    Part Number: INA210 There are various INA21xA/B/C devices. Why are the trailing letters different?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: What is the difference between the INA199A, INA199B and INA199C devices?

    Manuel Chavez
    Manuel Chavez
    Part Number: INA199 There are multiple versions of the INA199, ending with A#, B#, and C#. What is different between versions?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Some plots in the data sheet are noted as only for INA199A3. What about INA199A1 and INA199A2?

    Manuel Chavez
    Manuel Chavez
    Part Number: INA199 The INA199 data sheet says typical characteristic plots were measured with the INA199A3. Are curves for the INA199A1 and INA199A2 identical?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA3221: Input Bias Current & Impedance Specs for Bus Voltage Monitors

    Peter Iliya
    Peter Iliya
    Part Number: INA3221 Other Parts Discussed in Thread: INA219 , INA231 , INA230 , INA226 , INA220 Some power monitors contain "input bias current || input impedance" specifications. How do these properties affect design and implementation of these devices…
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA190: How Offset (Vos) and Bias Currents (IB) Affect Low Current Measurements

    Peter Iliya
    Peter Iliya
    Part Number: INA190 Other Parts Discussed in Thread: INA240 , INA138 , INA216 , INA270 , INA193 , INA203 , INA200 , INA226 , INA170 , LMP8645 , INA223 , INA282 , INA210 , INA199-Q1 , INA180 , INA181 , INA121 What are the design considerations when making…
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Does power sequencing for my current shunt monitor matter?

    Patrick Simmons
    Patrick Simmons
    Part Number: INA199 I expect that when I turn on my system, there will be a delay between when my microcontroller is ready for measurement and when my INA199 is properly powered on. Will this produce errors in my microcontroller readings?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Dealing with device protection when you can't exceed -0.3V

    Mitch M
    Mitch M
    Part Number: INA199 How do I protect against reverse current when I can only allow my signal to be 0.3V below ground?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Closed Loop Output Impedance and Output Compensation for Capacitive Load Stability

    Mitch M
    Mitch M
    Part Number: INA199 Other Parts Discussed in Thread: TINA-TI , How do I use the closed loop output impedance (Zout) to stabilize the output of a current sense amplifier with a capacitive load?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    AMC1301: AMC1301 Bias & Common mode 0 Locked

    171 views
    4 replies
    Latest 2 months ago
    by Jiri Panacek85
  • Answered

    INA226: Connection of VBus before or after the shunt 0 Locked

    119 views
    2 replies
    Latest 2 months ago
    by Moritz
  • Answered

    LMH7322: Deterministic jitter 0 Locked

    100 views
    1 reply
    Latest 2 months ago
    by HO SIU
  • Suggested Answer

    TLV9064: Device recommendation for appliance customer 0 Locked

    120 views
    3 replies
    Latest 2 months ago
    by Marek Lis
  • Suggested Answer

    TLV9002: TLV9002 design support 0 Locked

    190 views
    8 replies
    Latest 2 months ago
    by Marek Lis
  • Suggested Answer

    LM111: Thermal Resistance, Junction to Ambient value 0 Locked

    107 views
    2 replies
    Latest 2 months ago
    by Paul Grohe
  • Suggested Answer

    LMH6703: LMH6703MF/NOPB 0 Locked

    93 views
    1 reply
    Latest 2 months ago
    by Ignacio Vazquez Lam1
  • Suggested Answer

    TL331: Query on pullup for open collector output 0 Locked

    114 views
    2 replies
    Latest 2 months ago
    by Paul Grohe
  • Suggested Answer

    INA241A: Can we use this part in a converter with switching freq of 500kHz? 0 Locked

    83 views
    1 reply
    Latest 2 months ago
    by Carolus Andrews
  • Answered

    LM119QML-SP: Lead Seal Material 0 Locked

    91 views
    2 replies
    Latest 2 months ago
    by Paul Grohe
  • Suggested Answer

    UCC12050EVM-022: 13 Ways To Contact How can i talk to someone at Price-line®︎: A Step By Step Guide 0 Locked

    742 views
    1 reply
    Latest 2 months ago
    by Steven Mappus1
  • Not Answered

    TL331: TL331 as square wave generator 0 Locked

    105 views
    1 reply
    Latest 2 months ago
    by Ron Michallick
  • Not Answered

    TLV1824: Sink Current Specs 0 Locked

    55 views
    1 reply
    Latest 2 months ago
    by Ron Michallick
  • Suggested Answer

    LMP7701: Request for Design Review: Unity-Gain Buffer with Capacitive Load – Feedback vs. Riso Isolation 0 Locked

    112 views
    1 reply
    Latest 2 months ago
    by Raymond Zhang1
  • Suggested Answer

    TLV9062-Q1: Strange power up waveform 0 Locked

    87 views
    1 reply
    Latest 2 months ago
    by Ron Michallick
  • Suggested Answer

    OPA354: Please help to suggest High-speed Op-amp part for sense current waveform 0 Locked

    136 views
    1 reply
    Latest 2 months ago
    by Vikas Jeevannavar
  • Suggested Answer

    TPS563206: SCH Review 0 Locked

    76 views
    1 reply
    Latest 2 months ago
    by Gautam Iyer
  • Not Answered

    INA950-SEP: Engineering alternative for validation 0 Locked

    121 views
    1 reply
    Latest 2 months ago
    by Levi DV
  • Suggested Answer

    INA239: INA239 ADC converter MISO always tri-state 0 Locked

    340 views
    13 replies
    Latest 2 months ago
    by Guang Zhou
  • Answered

    TLV1871: How to use this TLV1871 for Inverting and Non-Inverting with Hyteresis 0 Locked

    286 views
    4 replies
    Latest 2 months ago
    by HO SIU
<>