TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    DAC80508: IAM NOT ABLE GET ANY VOLTAGE 0 Locked

    234 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Answered

    AMC1204EVM: layout pattern 0 Locked

    524 views
    3 replies
    Latest over 5 years ago
    by Tom Hendrick
  • Answered

    DAC38RF82EVM: DAC38RF8X EVM GUI has a limits on DAC's sample clcok? 0 Locked

    698 views
    2 replies
    Latest over 5 years ago
    by XiaoTao Ng
  • Suggested Answer

    AMC7812B: Switch GPIO pin into output channel 0 Locked

    265 views
    4 replies
    Latest over 5 years ago
    by Jie_Jiang
  • Answered

    ADS8900BEVM-PDK: Unipolar Reference Selection is noisy when inputs are grounded 0 Locked

    445 views
    5 replies
    Latest over 5 years ago
    by Erik Anderson41
  • Not Answered

    ADC32RF44EVM: KCU105 vs ADC32RFXX EVM GUI configurations 0 Locked

    459 views
    2 replies
    Latest over 5 years ago
    by Vijayendra Varma Siddamsetty
  • Answered

    ADS124S08: maximum SPI frequency can handle 0 Locked

    619 views
    2 replies
    Latest over 5 years ago
    by Jonathan Geronga
  • Suggested Answer

    ADS131A04EVM: Evaluation with modified ADS131A04EVM 0 Locked

    375 views
    1 reply
    Latest over 5 years ago
    by Joseph Wu
  • Suggested Answer

    ADS8325: ADS8325 reference code 0 Locked

    363 views
    1 reply
    Latest over 5 years ago
    by Cynthia
  • Answered

    ADS1282: Thermal Resistances 0 Locked

    235 views
    4 replies
    Latest over 5 years ago
    by Elisha Tarroza71
  • Not Answered

    DAC60508: Unable to readback DAC60508 ChipID and also can't get DAC channel output 0 Locked

    545 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    ADC12J1600: ADC12J1600: JESD204B data format and data mapping 0 Locked

    581 views
    5 replies
    Latest over 5 years ago
    by jim s
  • Suggested Answer

    ADS1298ECGFE-PDK: Channel Graphs 0 Locked

    288 views
    1 reply
    Latest over 5 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS1292R: Queries about ADS1292R 0 Locked

    249 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    ADC12D1620QML-SP: expected level of Fs/4 spur 0 Locked

    341 views
    7 replies
    Latest over 5 years ago
    by Franke Kurt
  • Suggested Answer

    ADC12DJ5200RF: The waveform appears to be modulated 0 Locked

    672 views
    11 replies
    Latest over 5 years ago
    by user5788058
  • Suggested Answer

    TSW14J57EVM: PROGRAMMING THROUGH FPGA 0 Locked

    517 views
    3 replies
    Latest over 5 years ago
    by jim s
  • Answered

    ADS7952: Troubleshooting to get reliable readings from ADS7952 over mibSPI 0 Locked

    355 views
    2 replies
    Latest over 5 years ago
    by Junaid Jawed Khan
  • Suggested Answer

    ADC12DJ3200: Length Matching between data lanes of 3 ADC12DJ3200 for Synchronization 0 Locked

    328 views
    1 reply
    Latest over 5 years ago
    by Rob Reeder
  • Not Answered

    AFE5809: How to use AFE5809 0 Locked

    433 views
    1 reply
    Latest over 5 years ago
    by Chen Kung
<>