TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    AFE4490: AFE4490 Power Supply 0 Locked

    418 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Suggested Answer

    AFE4300: AFE4300 frequency 0 Locked

    397 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Suggested Answer

    AFE4490: Help about calculation SpO2 0 Locked

    412 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Suggested Answer

    ADS5474-SP: timing analysis questions 0 Locked

    639 views
    3 replies
    Latest over 6 years ago
    by Michael T Schneider
  • Answered

    ADS1263: ADCPro v2 Sources 0 Locked

    444 views
    1 reply
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS1299: What are the possible reasons for heating up of ADS1299? 0 Locked

    1402 views
    9 replies
    Latest over 6 years ago
    by Tom Hendrick
  • Answered

    hdmi to rgb converter ic (looking for) 0 Locked

    1825 views
    2 replies
    Latest over 6 years ago
    by omeraygor
  • Suggested Answer

    ADS1294: Timing after TI_STOP and TI_START commands 0 Locked

    481 views
    3 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS8586S: Measurement Error 0 Locked

    1724 views
    9 replies
    Latest over 6 years ago
    by Dale Li
  • Answered

    DAC121C085: Seperating Grounds with isolator 0 Locked

    1498 views
    3 replies
    Latest over 6 years ago
    by Kevin Duke
  • Answered

    DAC8760EVM: DAC 8760 EVM Software Installation 0 Locked

    463 views
    2 replies
    Latest over 6 years ago
    by Kevin Duke
  • Answered

    ADS1015: How to configure ADS1015 ALERT/RDY pin as comparator output in continuous-conversion mode? 0 Locked

    959 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Answered

    TLV5630: not able to get proper output 0 Locked

    557 views
    3 replies
    Latest over 6 years ago
    by Kevin Duke
  • Answered

    ADC16DV160: SNR and SFDR for Fin=1100MHz 0 Locked

    382 views
    1 reply
    Latest over 6 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    ADS4249: Turn off one of the channels 0 Locked

    289 views
    2 replies
    Latest over 6 years ago
    by jim s
  • Suggested Answer

    ADS1252: ADS1252 External reference circuit for +5 to -5 voltage range 0 Locked

    3535 views
    17 replies
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    DAC37J84: Power Supply Noise Level Requirement 0 Locked

    229 views
    1 reply
    Latest over 6 years ago
    by Kang Hsia
  • Answered

    DAC38RF82: PLL Unlock Alarm 0 Locked

    1115 views
    9 replies
    Latest over 6 years ago
    by KAEDE KUDO
  • Suggested Answer

    TLC5960: TLC5960 Flashing 0 Locked

    382 views
    3 replies
    Latest over 6 years ago
    by allan chiang
  • Suggested Answer

    ADS1248: ADS1248 system monitor 0 Locked

    572 views
    3 replies
    Latest over 6 years ago
    by Ritesh U
<>