TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADC12J4000 - Your recommendation for SYSREF type 0 Locked

    583 views
    2 replies
    Latest over 8 years ago
    by Hiroshi Katsunaga
  • Answered

    ADC12J4000 - How to configure DC Coupled SYSREF 0 Locked

    1321 views
    2 replies
    Latest over 8 years ago
    by Hiroshi Katsunaga
  • Suggested Answer

    Which TI module can I use to interface an inductive sensor output to a Microprocessor digital input 0 Locked

    493 views
    5 replies
    Latest over 8 years ago
    by Ankit Parikh
  • Suggested Answer

    How can I converting PT100 resistance on ADS1256 0 Locked

    1559 views
    1 reply
    Latest over 8 years ago
    by Christopher Hall
  • Answered

    ADS1262 EVM PGARAIL_FAULT with ADCPro 0 Locked

    1210 views
    8 replies
    Latest over 8 years ago
    by Christopher Hall
  • Suggested Answer

    ADS1256 and sliding pot meter and load cell schematic 0 Locked

    2546 views
    1 reply
    Latest over 8 years ago
    by Christopher Hall
  • Answered

    TVP7002 - Timing requirements between PWDN and RESETB 0 Locked

    1747 views
    2 replies
    Latest over 8 years ago
    by Steve Clynes
  • Suggested Answer

    ADC08b200, WEN signal 0 Locked

    576 views
    2 replies
    Latest over 8 years ago
    by Daniel Pineau
  • Not Answered

    ADC input current and Linearity and also anti aliasing filter design 0 Locked

    473 views
    2 replies
    Latest over 8 years ago
    by Hari T O0
  • Answered

    AMC7812B DC Specs 0 Locked

    686 views
    5 replies
    Latest over 8 years ago
    by Matthew Sauceda
  • Not Answered

    THS8135 how to set M1/M2/SYNC/SYNC_T/BLANK pin 0 Locked

    453 views
    0 replies
    Started over 8 years ago
    by user4520175
  • Suggested Answer

    ADS8363 0 Locked

    396 views
    1 reply
    Latest over 8 years ago
    by RahulVK
  • Not Answered

    A/D Converter Selection for Application 0 Locked

    555 views
    2 replies
    Latest over 8 years ago
    by FRK
  • Not Answered

    ADS62P48 0 Locked

    861 views
    1 reply
    Latest over 8 years ago
    by Richard Prentice
  • Not Answered

    ad7846 X position problem 0 Locked

    1114 views
    3 replies
    Latest over 8 years ago
    by José Luis
  • Suggested Answer

    TLV5619 interface? 0 Locked

    513 views
    3 replies
    Latest over 8 years ago
    by Paul_Frost
  • Answered

    TSC2008EVM 0 Locked

    1597 views
    5 replies
    Latest over 8 years ago
    by José Luis
  • Answered

    DAC38J82 output SFDR and Harmonics does not meet at particular decimal frequencies 0 Locked

    1286 views
    10 replies
    Latest over 8 years ago
    by Ken C
  • Suggested Answer

    ADC12J2700 JESD204B Questions 0 Locked

    752 views
    2 replies
    Latest over 8 years ago
    by Richard Elmquist
  • Suggested Answer

    ADS1278EVM-PDK driver download error 0 Locked

    1012 views
    2 replies
    Latest over 8 years ago
    by sulang liu
<>