TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS1220 Single-ended shorted input 0 Locked

    761 views
    2 replies
    Latest over 9 years ago
    by Samuel Tal
  • Answered

    ADC-WB-BB SMA pitch, gerber 0 Locked

    1088 views
    2 replies
    Latest over 9 years ago
    by Juanda Juanda
  • Suggested Answer

    couldnt found ADC to full fill below requirement 0 Locked

    897 views
    6 replies
    Latest over 9 years ago
    by Bhavdipsinh Rathod
  • Answered

    ADS54J66: Powering 0 Locked

    878 views
    3 replies
    Latest over 9 years ago
    by jim s
  • Answered

    ADS1115 internal MUX control 0 Locked

    1188 views
    1 reply
    Latest over 9 years ago
    by Krunal Maniar
  • Not Answered

    ADC08D1520QML-SP Group Delay 0 Locked

    502 views
    1 reply
    Latest over 9 years ago
    by Kirby Kruckmeyer96848
  • Suggested Answer

    ADS7956: General Questions for initialization 0 Locked

    636 views
    1 reply
    Latest over 9 years ago
    by Cynthia
  • Not Answered

    ADS7956 Data Values don't match device specification 0 Locked

    504 views
    1 reply
    Latest over 9 years ago
    by Cynthia
  • Suggested Answer

    ADS1x9x evm source code 0 Locked

    1852 views
    6 replies
    Latest over 9 years ago
    by Mohsen Hooshmand
  • Suggested Answer

    Temperature of ADS1602 0 Locked

    876 views
    2 replies
    Latest over 9 years ago
    by Pavel Haintz
  • Suggested Answer

    ADC12J4000 - Can it work at 800MSPS ? 0 Locked

    500 views
    1 reply
    Latest over 9 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    ADS1018-Q1 Reference design 0 Locked

    680 views
    2 replies
    Latest over 9 years ago
    by Krunal Maniar
  • Not Answered

    Power supply adapter for Evaluation Module. 0 Locked

    661 views
    1 reply
    Latest over 9 years ago
    by jim s
  • Suggested Answer

    problem in reading the digital count from ADS7825 in parallel mode 0 Locked

    1615 views
    2 replies
    Latest over 9 years ago
    by B M S RAO
  • Answered

    ADC12J4000 SFDR vs Decimation Factor 0 Locked

    1022 views
    2 replies
    Latest over 9 years ago
    by Mo.
  • Answered

    ADS8528 data conversion not stable 0 Locked

    921 views
    4 replies
    Latest over 9 years ago
    by Dale Li
  • Suggested Answer

    ADS1262 Gain error calibration method 0 Locked

    1230 views
    1 reply
    Latest over 9 years ago
    by Christopher Hall
  • Suggested Answer

    SYNC lock issue with ADC12J4000 with KC-705 0 Locked

    1848 views
    13 replies
    Latest over 9 years ago
    by deepak kumar32
  • Suggested Answer

    Software .xml file for DAC8832 0 Locked

    1240 views
    3 replies
    Latest over 9 years ago
    by Samuel Jaffe
  • Answered

    Operation of the ADS9110EMV 0 Locked

    1205 views
    6 replies
    Latest over 9 years ago
    by Luis Chioye
<>