TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADC128S102QML - Opto question 0 Locked

    466 views
    1 reply
    Latest over 9 years ago
    by Michael Stout
  • Not Answered

    ADS54J60 SPI 0 Locked

    1031 views
    3 replies
    Latest over 9 years ago
    by jim s
  • Answered

    ADS1282EVM-PDK connected to a SM24 geophone 0 Locked

    3491 views
    13 replies
    Latest over 9 years ago
    by Christopher Hall
  • Suggested Answer

    is there a way to use ADC12D1800RF without wave vision 5 0 Locked

    674 views
    1 reply
    Latest over 9 years ago
    by Jim Brinkhurst1
  • Not Answered

    Recommended touchscreen device 0 Locked

    1026 views
    1 reply
    Latest over 9 years ago
    by Andy Liu (BMS)
  • Answered

    ADS1296R Upon Power Up DRDY Line never goes low 0 Locked

    1072 views
    6 replies
    Latest over 9 years ago
    by Mike Kemmerer
  • Not Answered

    ADC32RF45EVM .INI Files 0 Locked

    718 views
    4 replies
    Latest over 9 years ago
    by Marshall Beck
  • Not Answered

    DAC34SH84 Evaluation Module DAC-FMC Adapter does not fit 0 Locked

    623 views
    1 reply
    Latest over 9 years ago
    by Kang Hsia
  • Discussion

    ADS1298R Power Consumption Locked

    2271 views
    12 replies
    Latest over 9 years ago
    by Brian Pisani
  • Answered

    ADS42LB69 - SNR versus Input Frequency and External Clock Jitter 0 Locked

    814 views
    1 reply
    Latest over 9 years ago
    by Thomas Neu
  • Answered

    DAC37J82 Register 0x3E config62 0 Locked

    697 views
    2 replies
    Latest over 9 years ago
    by Chris449
  • Answered

    ADS1248 unipolar mode with negative vaules 0 Locked

    764 views
    3 replies
    Latest over 9 years ago
    by Joseph Wu
  • Not Answered

    ADC requirements 0 Locked

    407 views
    2 replies
    Latest over 9 years ago
    by Jose Duenas
  • Suggested Answer

    ADS1298ECGFE demo program, no firmware found 0 Locked

    849 views
    3 replies
    Latest over 9 years ago
    by Brian Pisani
  • Answered

    Tie thermal pad of LMP90080 to ground? 0 Locked

    1149 views
    5 replies
    Latest over 9 years ago
    by Jason Pittenger
  • Answered

    Thermal pad connection on LMP90077, LMP90078, LMP90079 and LMP90080 0 Locked

    839 views
    4 replies
    Latest over 9 years ago
    by Jason Pittenger
  • Answered

    Help me! I can not install USBStyx Driver !!! 0 Locked

    5636 views
    12 replies
    Latest over 9 years ago
    by Guillaume Trubert
  • Answered

    Dac37J82 Config95 0 Locked

    373 views
    2 replies
    Latest over 9 years ago
    by Chris449
  • Not Answered

    Interfacing with AFE4403 watch EVM 0 Locked

    968 views
    3 replies
    Latest over 9 years ago
    by Chi Zhang92
  • Suggested Answer

    Wavevision 5 ASCII import 0 Locked

    827 views
    2 replies
    Latest over 9 years ago
    by Jeff Bateman
<>