TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS1248EVM-PDK installation problem 0 Locked

    3742 views
    29 replies
    Latest over 15 years ago
    by BOUQUET Hugo
  • Answered

    ADS7280 0 Locked

    771 views
    5 replies
    Latest over 15 years ago
    by Rodrigo Ladeira
  • Answered

    ADS1158 - Intermittent Correct data - DRDY pin stays Low! 0 Locked

    936 views
    6 replies
    Latest over 15 years ago
    by Larry West
  • Answered

    ADS1256 Beta software 0 Locked

    1634 views
    14 replies
    Latest over 15 years ago
    by john ivory
  • Answered

    DAC Linearity error variance chip to chip 0 Locked

    511 views
    2 replies
    Latest over 15 years ago
    by David Mittmann
  • Answered

    ADS1282 0 Locked

    376 views
    1 reply
    Latest over 15 years ago
    by Joseph Wu
  • Answered

    Newsletter typo 0 Locked

    252 views
    1 reply
    Latest over 15 years ago
    by Kang Hsia
  • Suggested Answer

    CD54HC123 Pulse Width 0 Locked

    525 views
    1 reply
    Latest over 15 years ago
    by Wade Vonbergen
  • Answered

    TLV5610IDW 0 Locked

    325 views
    1 reply
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    Hi-Speed Layout on ADS5400 EVM 0 Locked

    954 views
    10 replies
    Latest over 15 years ago
    by Richard Prentice
  • Answered

    Availability of the ADS5400? 0 Locked

    399 views
    3 replies
    Latest over 15 years ago
    by Sannatizer35
  • Answered

    Antialiasing filter in the ADS1254 0 Locked

    441 views
    1 reply
    Latest over 15 years ago
    by Joseph Wu
  • Answered

    ads1282 modulator check up 0 Locked

    625 views
    3 replies
    Latest over 15 years ago
    by ralph reiter
  • Answered

    ADS1248 installation issues 0 Locked

    369 views
    2 replies
    Latest over 15 years ago
    by BOUQUET Hugo
  • Answered

    ADS1256 used with MMB0 Development Board. 0 Locked

    460 views
    2 replies
    Latest over 15 years ago
    by john ivory
  • Answered

    How come all the measurement of my ADS1258 off by -0.02 volts? 0 Locked

    2114 views
    13 replies
    Latest over 15 years ago
    by Joseph Wu
  • Answered

    ADS7953 - trouble reading data 0 Locked

    2235 views
    8 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    Why my DAC2904-EVM does not have analog output? 0 Locked

    604 views
    9 replies
    Latest over 15 years ago
    by Hamza Fraz
  • Answered

    system/self calibration for ADS1243 0 Locked

    525 views
    2 replies
    Latest over 15 years ago
    by jack meng
  • Answered

    New to Data Conversion and need some help! ADS6422 interfacing. 0 Locked

    1117 views
    6 replies
    Latest over 15 years ago
    by Richard Prentice
<>