TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS131M08: How can I accurately measure the internal reference voltage? 0 Locked

    441 views
    5 replies
    Latest over 1 year ago
    by Dale Li
  • Not Answered

    ADC3683: Jitter on DCLKIN 0 Locked

    316 views
    2 replies
    Latest over 1 year ago
    by Drew Harrell
  • Not Answered

    AFE4490: Afe 4490 data capture 0 Locked

    267 views
    1 reply
    Latest over 1 year ago
    by Rajkumar S
  • Answered

    ADS8556: unused analog pin 0 Locked

    311 views
    3 replies
    Latest over 1 year ago
    by Tom Hendrick
  • Suggested Answer

    ADS1147: If there is any risk to use the SPI with 2.1M-2.3M SCLK to communicate with ADS1147 0 Locked

    288 views
    3 replies
    Latest over 1 year ago
    by Bryan Lizon86
  • Not Answered

    AFE4500EVM: Access to documentation 0 Locked

    224 views
    0 replies
    Started over 1 year ago
    by Patryk Invis Sp. z o.o.
  • Answered

    AFE5816: Problems in AFE output test pattern data 0 Locked

    509 views
    8 replies
    Latest over 1 year ago
    by Sachin H K
  • Answered

    ADS1278: How to measure 5V Analog IN using ADS1278 0 Locked

    565 views
    14 replies
    Latest over 1 year ago
    by Jayanthan V
  • Answered

    ADS1114: Different Pull up voltage for I2C lines than VDD supply 0 Locked

    354 views
    3 replies
    Latest over 1 year ago
    by Joachim Wuerker
  • Suggested Answer

    DAC63204EVM: command line interface 0 Locked

    205 views
    1 reply
    Latest over 1 year ago
    by Paul_Frost
  • Not Answered

    LMP92066EVM: Trouble with LMP92066 GUI 0 Locked

    208 views
    1 reply
    Latest over 1 year ago
    by Erin Bowrie
  • Answered

    ADS127L18EVM-PDK: Error message 0xFFFFEC78 0 Locked

    503 views
    7 replies
    Latest over 1 year ago
    by Keith Nicholas
  • Not Answered

    ADC128S022: Accuracy error in multi-channel ADC read 0 Locked

    250 views
    1 reply
    Latest over 1 year ago
    by Joel Meraz
  • Answered

    ADS8689: CONVST/CS and SCLK are LOW when RST low-to-high transition? 0 Locked

    352 views
    1 reply
    Latest over 1 year ago
    by Tom Hendrick
  • Suggested Answer

    ADS124S08EVM: Data converters forum 0 Locked

    404 views
    3 replies
    Latest over 1 year ago
    by Bob Benjamin
  • Not Answered

    ADC12DJ5200RFEVM:  ADC12DJ5200RFEVM:how to use the software of ADC12DJ5200RFEVM correctly 0 Locked

    192 views
    0 replies
    Started over 1 year ago
    by ?? ?
  • Answered

    DAC81416EVM: DAC Voltage Register Always Reads Back 0 0 Locked

    353 views
    4 replies
    Latest over 1 year ago
    by Oscar Chen
  • Suggested Answer

    ADS7952: Need FIT Rate 0 Locked

    277 views
    1 reply
    Latest over 1 year ago
    by Tom Hendrick
  • Not Answered

    ADS7852: Recovering from power glitch 0 Locked

    336 views
    5 replies
    Latest over 1 year ago
    by Tom Hendrick
  • Suggested Answer

    ADS8664: ADC reading freeze 0 Locked

    541 views
    19 replies
    Latest over 1 year ago
    by Tom Hendrick
<>