TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADS5294: ADS5294 power sequencing requirements 0

    11 views
    0 replies
    Started 1 day ago
    by Grant Childs
  • Not Answered

    DAC11001A: DAC81001, DAC91001, DAC11001: How long does temperature calibration take? 0

    76 views
    3 replies
    Latest 1 day ago
    by Sanjay
  • Answered

    DAC11001B: Output impedance of SDO 0

    69 views
    7 replies
    Latest 1 day ago
    by Sanjay
  • Answered

    ADS1235: Using ADS1235 in Single Ended Mode? 0

    54 views
    4 replies
    Latest 1 day ago
    by Bryan Lizon86
  • Answered

    ADS1299-4: about precision, Gain Error 0

    46 views
    3 replies
    Latest 1 day ago
    by Hidetaka Kudo
  • Suggested Answer

    ADS54J69: Regarding suggestion on ADC and DAC for mentioned specifications 0

    45 views
    1 reply
    Latest 1 day ago
    by Gowtham Pandiarajan
  • Not Answered

    DAC81416-08EVM: Gerber file request 0

    35 views
    1 reply
    Latest 1 day ago
    by Sanjay
  • Not Answered

    ADS1147: The data read from the register is inconsistent with the configuration. 0

    65 views
    3 replies
    Latest 2 days ago
    by YUCHUN GUO
  • Not Answered

    AFE58JD28EVM: The screen keeps saying "loading main. Vi...” 0

    33 views
    1 reply
    Latest 2 days ago
    by Suri Chen
  • Not Answered

    DAC5672A: Interleaved mode acccess 0

    57 views
    2 replies
    Latest 2 days ago
    by Gil Hershman71
  • Not Answered

    AMC0336-Q1: Full scale range for HVDC 0

    81 views
    4 replies
    Latest 2 days ago
    by Tom Hendrick
  • Suggested Answer

    AMC1303M0520: CLKOUT config 0

    44 views
    1 reply
    Latest 3 days ago
    by Tom Hendrick
  • Suggested Answer

    ADC3644: DC Offset temination loading 0

    101 views
    4 replies
    Latest 4 days ago
    by Felipe Sandoval
  • Suggested Answer

    LMR38020: CB report for IEC 62368-1 0

    69 views
    1 reply
    Latest 4 days ago
    by Richard Fu22
  • Not Answered

    ADS1219: Device selection 0

    62 views
    2 replies
    Latest 4 days ago
    by Jiyah Starks
  • Not Answered

    DAC80502: The humanoid robot customer is extremely anxious about the application issue of the chip 0

    82 views
    4 replies
    Latest 4 days ago
    by Katlynne Jones
  • Not Answered

    ADS1231: ADS1231 0

    131 views
    6 replies
    Latest 4 days ago
    by Keith Nicholas
  • Suggested Answer

    ADS7961-Q1: Powe up sequence, CHX earlier than Vx 0

    64 views
    4 replies
    Latest 4 days ago
    by Joel Meraz
  • Not Answered

    ADS1262: Input impedance variation 0

    107 views
    7 replies
    Latest 4 days ago
    by Bryan Lizon86
  • Not Answered

    ADC3543: Using single ended clock. Trouble getting part configured and data output 0

    90 views
    7 replies
    Latest 4 days ago
    by Rob Reeder
<>