TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS7138-Q1: SYSTEM_STATUS register and related registers 0 Locked

    161 views
    1 reply
    Latest over 3 years ago
    by Cynthia
  • Answered

    ADS7138-Q1: GENERAL_CFG unused registers 0 Locked

    236 views
    1 reply
    Latest over 3 years ago
    by Cynthia
  • Suggested Answer

    ADS8881: How to measure ENOB(DC) and PCB layout improvement 0 Locked

    407 views
    1 reply
    Latest over 3 years ago
    by Cynthia
  • Not Answered

    ADS131M08 Precision ADC 0 Locked

    302 views
    3 replies
    Latest over 3 years ago
    by Cole Macias
  • Not Answered

    AFE4410: Schematic and Layout Validation 0 Locked

    176 views
    1 reply
    Latest over 3 years ago
    by Nick Zahabizadeh
  • Suggested Answer

    DAC7553: Require case Temperature , junction ambient thermal resistance, junction case thermal resistance for Part Number DAC7553IRGTR 0 Locked

    300 views
    4 replies
    Latest over 3 years ago
    by Katlynne Jones
  • Answered

    ADS1220: fdiff & fcm 0 Locked

    195 views
    2 replies
    Latest over 3 years ago
    by kwon
  • Answered

    ADS7953: how to understand Tq? 0 Locked

    330 views
    3 replies
    Latest over 3 years ago
    by Cynthia
  • Not Answered

    ADC3663: ADC output problem after power down and then up 0 Locked

    329 views
    11 replies
    Latest over 3 years ago
    by Chase W
  • Suggested Answer

    ADC3662EVM: Schematic Diagram 0 Locked

    1189 views
    3 replies
    Latest over 3 years ago
    by Amy
  • Suggested Answer

    ADS1248: Reading and Writing to registers is working even when START pin is held low. 0 Locked

    373 views
    5 replies
    Latest over 3 years ago
    by Bryan Lizon86
  • Suggested Answer

    ADS1158: ADS1158 DRDY pin not going LOW 0 Locked

    520 views
    18 replies
    Latest over 3 years ago
    by Bryan Lizon86
  • Answered

    ADS4122: What is HI PERF MODE? 0 Locked

    219 views
    2 replies
    Latest over 3 years ago
    by Charlie Xiao
  • Answered

    DAC81404: Read operation possible in Daisy Chain ? 0 Locked

    311 views
    2 replies
    Latest over 3 years ago
    by mmg IPG
  • Not Answered

    DAC8830: Is it possible to get 0-5V output from a 2.5Vref? 0 Locked

    155 views
    1 reply
    Latest over 3 years ago
    by Akhilesh K
  • Suggested Answer

    ADS1263: Clarifying design consideration 0 Locked

    578 views
    3 replies
    Latest over 3 years ago
    by Bryan Lizon86
  • Not Answered

    ADS8350: Single Channel Alternative 0 Locked

    219 views
    1 reply
    Latest over 3 years ago
    by Tom Hendrick
  • Answered

    AMC1400: What is the best option to interface it with MCU? 0 Locked

    236 views
    1 reply
    Latest over 3 years ago
    by Tom Hendrick
  • Answered

    TLA2518: SPI Bus Loading 0 Locked

    431 views
    1 reply
    Latest over 3 years ago
    by Cynthia
  • Answered

    ADS5287: External reference and switching current 0 Locked

    225 views
    2 replies
    Latest over 3 years ago
    by David Elliott
<>