TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DAC39RF10: CAN I use JMODE=2 for 1 real data stream? 0

    44 views
    1 reply
    Latest 7 days ago
    by Matthew Kramer
  • Suggested Answer

    ADC12DJ3200: Configure using labVIEW 0

    112 views
    7 replies
    Latest 7 days ago
    by Geoff Roth
  • Suggested Answer

    ADS1261-Q1: Number of winston bridge interface with ADS1261-Q1 0

    53 views
    1 reply
    Latest 7 days ago
    by Bryan Lizon86
  • Answered

    ADS124S06: How to set the register 0

    182 views
    10 replies
    Latest 7 days ago
    by Bryan Lizon86
  • Suggested Answer

    ADS124S06: Are ADS124S06 and ADS114S06 compatible for register map and DC / AC specs? 0

    38 views
    1 reply
    Latest 7 days ago
    by Bryan Lizon86
  • Not Answered

    AFE7900EVM: We are using ZCU102 with AFE7900EVM 0

    48 views
    1 reply
    Latest 7 days ago
    by Mahesh Kumar Madduri
  • Suggested Answer

    UCC28631: UCC28631DR 0

    120 views
    8 replies
    Latest 7 days ago
    by JCHK
  • Suggested Answer

    ADS1198: ADS1198 RLD OFF 0

    57 views
    2 replies
    Latest 7 days ago
    by Vladimir Gomon
  • Suggested Answer

    ADS131E08: overshoot undershoot at ADC power supply line 0

    51 views
    3 replies
    Latest 7 days ago
    by Dale Li
  • Not Answered

    AFE58JD48: ADC Latency using LVDS Outputs 0

    20 views
    0 replies
    Started 8 days ago
    by Steve Claffey
  • Answered

    ADS8688: Help with strange results from ADS8688 0

    33 views
    1 reply
    Latest 8 days ago
    by Barney
  • Not Answered

    DAC60096: System-Level Debugging of PIC MCU with DAC60096 0

    60 views
    1 reply
    Latest 8 days ago
    by Paul_Frost
  • Not Answered

    ADS1219: UL & VDE certification 0

    65 views
    2 replies
    Latest 8 days ago
    by Andrew Kalthoff
  • Not Answered

    ADS1015-Q1: Need Info on I2C and Alert Connection 0

    47 views
    2 replies
    Latest 8 days ago
    by Andrew Kalthoff
  • Suggested Answer

    ADS131M03-Q1: Averaging at Global-chop mode 0

    199 views
    14 replies
    Latest 8 days ago
    by Bryan Lizon86
  • Suggested Answer

    ADS124S06: Unable to read data on continuous mode, DRDY pin is being high all the time. 0

    165 views
    4 replies
    Latest 8 days ago
    by Bryan Lizon86
  • Answered

    AFE4490: Unstable Heart-Rate and SpO₂ Readings with AFE4490 Breakout on nRF52840 – Sudden Spikes and Drops 0

    77 views
    2 replies
    Latest 8 days ago
    by sabith ch
  • Answered

    AFE58JD32: Configure AFE58JD32 to operate in ramp output mode 0

    51 views
    1 reply
    Latest 8 days ago
    by Lizzy
  • Not Answered

    TX7316EVM: Research Feasibility of Ultrasound Imaging Setup Using TX7316EVM + AFE5808A EVM 0

    34 views
    0 replies
    Started 8 days ago
    by Wang yuning
  • Answered

    ADC12QJ1600: JESD IP 0

    46 views
    1 reply
    Latest 8 days ago
    by Aaron McIntosh
<>