TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS90UB953-Q1: Imager Data Rate Support

    Casey McCrea
    Casey McCrea
    Part Number: DS90UB953-Q1 ​​​Can the DS90UB953-Q1 support my imager?
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How to force 10/100/1000 Mbps speed in Ethernet PHYs?

    Evan Mayhew
    Evan Mayhew
    Part Number: DP83867E Other Parts Discussed in Thread: USB-2-MDIO To force a specific speed, auto-negotiation is left enabled while disabling advertisements for all non-desired speeds. The scripts to do this in the USB-2-MDIO interface for the DP83867…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DS90C385A: Question about internal pull down resistor of input pins. 0 Locked

    284 views
    3 replies
    Latest over 2 years ago
    by Ikram Haque
  • Answered

    TCA9537: Reset not working 0 Locked

    423 views
    5 replies
    Latest over 2 years ago
    by Tyler Townsend
  • Suggested Answer

    TUSB501-Q1: short to battery 0 Locked

    531 views
    3 replies
    Latest over 2 years ago
    by Shane Hauser
  • Suggested Answer

    DS90C031:Regarding the terminal applied voltage DIN of DS90C031 0 Locked

    308 views
    1 reply
    Latest over 2 years ago
    by Joshua Salinas
  • Suggested Answer

    DS90C031: Regarding the terminal applied voltage DIN of DS90C031 0 Locked

    313 views
    1 reply
    Latest over 2 years ago
    by Joshua Salinas
  • Answered

    TFP410: Problem converting RGB666 TTL 0 Locked

    447 views
    3 replies
    Latest over 2 years ago
    by David (ASIC) Liu
  • Answered

    part no suggestion required 0 Locked

    467 views
    9 replies
    Latest over 2 years ago
    by Joshua Salinas
  • Answered

    TUSB8042: How to set Compliance Mode under Linux? 0 Locked

    369 views
    2 replies
    Latest over 2 years ago
    by Peter Szarvas
  • Answered

    TCA9539: Trying to generate PWM, how to switch to Fast-mode (400 KHz) 0 Locked

    407 views
    2 replies
    Latest over 2 years ago
    by Tyler Townsend
  • Suggested Answer

    TUSB3410 driver for Windows 11 0 Locked

    4397 views
    1 reply
    Latest over 2 years ago
    by Nicholaus_Malone
  • Answered

    DS160PT801: DS160PT801 0 Locked

    317 views
    1 reply
    Latest over 2 years ago
    by David Waier
  • Suggested Answer

    TUSB4041I: Request OTP tool for TUSB4041I 0 Locked

    483 views
    8 replies
    Latest over 2 years ago
    by Brian Zhou
  • Suggested Answer

    DS160PT801: DS160PT801 0 Locked

    396 views
    2 replies
    Latest over 2 years ago
    by David Waier
  • Answered

    TRS3243E: Data-rate difference between the datasheet and web description 0 Locked

    223 views
    2 replies
    Latest over 2 years ago
    by Tahara
  • Answered

    TCAN1145-Q1: About Errata 0 Locked

    233 views
    2 replies
    Latest over 2 years ago
    by Yuya Shoji
  • Not Answered

    TLK10232: High Speed SERDES control settings - can we use the reserved fields? 0 Locked

    291 views
    1 reply
    Latest over 2 years ago
    by Lucas Wolter
  • Answered

    TCA9548A: Can I have standard I2C mode on few outputs and fast I2C mode on the rest 0 Locked

    531 views
    3 replies
    Latest over 2 years ago
    by BOBBY
  • Not Answered

    DS90UB935-Q1: Static electricity test issue 0 Locked

    634 views
    15 replies
    Latest over 2 years ago
    by Cindy Li
  • Suggested Answer

    SN65HVD33: SN65HVD33DR Full Fail Safe 0 Locked

    343 views
    2 replies
    Latest over 2 years ago
    by BOBBY
  • Suggested Answer

    TCAN1044A-Q1: GT/B 41588.2-2022/ISO 11898-2:2016 ? 0 Locked

    484 views
    9 replies
    Latest over 2 years ago
    by Eric Schott1
<>