TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    SN55HVD251 and SN65HVD231 -- ISO11898 0 Locked

    687 views
    1 reply
    Latest over 14 years ago
    by Scott Monroe
  • Answered

    TLK100 question 0 Locked

    465 views
    1 reply
    Latest over 14 years ago
    by Ofir Ben Joseph
  • Answered

    XIO2001 with Freescal Processor 0 Locked

    350 views
    1 reply
    Latest over 14 years ago
    by -DK-
  • Answered

    XIO2000A causing PCIe errors on Dell R710 shutdown 0 Locked

    1665 views
    1 reply
    Latest over 14 years ago
    by -DK-
  • Answered

    ISO7220, ISO7221 storage temperature 0 Locked

    492 views
    1 reply
    Latest over 14 years ago
    by Neel Seshan
  • Answered

    TB3R1 Connections 0 Locked

    406 views
    1 reply
    Latest over 14 years ago
    by Atul Patel
  • Answered

    SN65HVD230 Issue 0 Locked

    4130 views
    6 replies
    Latest over 14 years ago
    by Sandeep Sirpatil
  • Answered

    SN75DP122A EMI problem 0 Locked

    671 views
    3 replies
    Latest over 14 years ago
    by Ken Shaw
  • Answered

    TUSB1310 0 Locked

    435 views
    1 reply
    Latest over 14 years ago
    by DHarmon
  • Not Answered

    Piccolo (F28035) I2C problem 0 Locked

    1549 views
    1 reply
    Latest over 14 years ago
    by Prasad Dhond
  • Not Answered

    Looking for PADS schematic symbols for these parts 0 Locked

    335 views
    1 reply
    Latest over 14 years ago
    by Hattie
  • Not Answered

    need of a line receiver 0 Locked

    269 views
    0 replies
    Started over 14 years ago
    by Joey Jabbour
  • Answered

    TPL9202 eight channel relay driver 0 Locked

    628 views
    1 reply
    Latest over 14 years ago
    by Ron Michallick
  • Not Answered

    slk2501OC-48 Muti-Rate SONET Transceiver 0 Locked

    388 views
    2 replies
    Latest over 14 years ago
    by Nikola Vranic
  • Answered

    TUSB2036 DP0PUR Question 0 Locked

    793 views
    3 replies
    Latest over 14 years ago
    by JMMN
  • Answered

    SN65LVDS250 output duty cycle spec 0 Locked

    432 views
    1 reply
    Latest over 15 years ago
    by Atul Patel
  • Not Answered

    slk2501 different clock? 0 Locked

    389 views
    3 replies
    Latest over 15 years ago
    by HA
  • Answered

    TUSB3410 driver installed under both "Multi-port serial adapters" and "Ports (COM & LPT)" 0 Locked

    5898 views
    8 replies
    Latest over 15 years ago
    by Suresh Kumar Ramu
  • Answered

    TUSB3410 - getting bMaxPower 0 Locked

    1967 views
    8 replies
    Latest over 15 years ago
    by thierry Didi
  • Answered

    Question: About the meaning of "Isolated" on the web(SN75C1167). 0 Locked

    1402 views
    2 replies
    Latest over 15 years ago
    by Toshiya Hiramatsu
<>