TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    PCA9545A: PCA9545APW - I2C Switch 0 Locked

    414 views
    2 replies
    Latest over 4 years ago
    by Danny Bacic
  • Suggested Answer

    DP83848M: DP83848M: DUT test mode entering method 0 Locked

    843 views
    7 replies
    Latest over 4 years ago
    by Gerome Cacho
  • Answered

    PCA9306: 200kohm requirement in case of Vref1=Vref2, pull up resistor placement 0 Locked

    463 views
    2 replies
    Latest over 4 years ago
    by Danny Bacic
  • Suggested Answer

    ONET1151L: propagation delay- variation part-to-part of this and other laser drivers 0 Locked

    385 views
    3 replies
    Latest over 4 years ago
    by Nasser Mohammadi
  • Suggested Answer

    SN65DSI86: Content protection? 0 Locked

    462 views
    3 replies
    Latest over 4 years ago
    by David (ASIC) Liu
  • Answered

    TCA9517: To know the max Low-level output current 0 Locked

    296 views
    1 reply
    Latest over 4 years ago
    by Eric Schott1
  • Suggested Answer

    PCA9555: How to config I/O port as input or out 0 Locked

    1775 views
    1 reply
    Latest over 4 years ago
    by Eric Schott1
  • Answered

    TPS25750: Sink without a battery charger? 0 Locked

    283 views
    1 reply
    Latest over 4 years ago
    by Chuck Branch
  • Answered

    DS280DF810: DS280DF810 Programming Guide 0 Locked

    286 views
    1 reply
    Latest over 4 years ago
    by Nasser Mohammadi
  • Answered

    Device driver of PCMCIA IC 0 Locked

    581 views
    4 replies
    Latest over 4 years ago
    by Danilo A.
  • Answered

    DS90UH940-Q1: mipi output when no input signal 0 Locked

    378 views
    4 replies
    Latest over 4 years ago
    by Jiashow Ho
  • Not Answered

    DP83TD510E-EVM: Unable to establish a SPE connection between two boards 0 Locked

    462 views
    5 replies
    Latest over 4 years ago
    by Gerome Cacho
  • Suggested Answer

    TCA9548A: Max Slave connection 0 Locked

    335 views
    1 reply
    Latest over 4 years ago
    by Clemens Ladisch
  • Answered

    TUSB211-Q1: How to open left side of eye pattern 0 Locked

    299 views
    1 reply
    Latest over 4 years ago
    by Malik Barton57
  • Not Answered

    DS90UB960-Q1: lag issue for ds90ub953+ds90ub960 0 Locked

    331 views
    7 replies
    Latest over 4 years ago
    by Sally Cheung95
  • Answered

    HD3SS3220: USB type C, DFP, connection confusion 0 Locked

    310 views
    3 replies
    Latest over 4 years ago
    by Brian Zhou
  • Not Answered

    TPS65987DDJ: TPS65987DDJ I2C interface 0 Locked

    714 views
    14 replies
    Latest over 4 years ago
    by Emma Hoying
  • Answered

    TPS65988:Only Source 0 Locked

    1793 views
    21 replies
    Latest over 4 years ago
    by Emma Hoying
  • Answered

    TMDS181: TMDS181 TMDS clock divided for HDMI2.0 0 Locked

    1593 views
    1 reply
    Latest over 4 years ago
    by David (ASIC) Liu
  • Answered

    DS90UH941AS-Q1: Display on the LCD screen is jumping up and down. Which parameters might be wrong? 0 Locked

    289 views
    1 reply
    Latest over 4 years ago
    by semiyd
<>