TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Interface Transceivers: E2E Homepage

    Ethan Sempsrott
    Ethan Sempsrott
    Welcome to the Interface Transceivers E2E page! Here you will find a variety of resources that support our long list of devices (750+ and counting!) Select an interface below to find a collection of FAQs, application notes, videos, and more: …
    • Answered
    • 5 months ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: How should PCIe signals be AC coupled?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS320PR1601 , DS160PR1601 Tool/software: How do I check to make sure my PCIe signals are AC-coupled correctly?
    • Answered
    • 5 months ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: RGMII Shift and Align Mode

    Nick Peabody
    Nick Peabody
    Part Number: DP83TC812S-Q1 Tool/software: Hello, Here is a summary of available information about RGMII Shift and Align mode for our DP83TC81x devices: A minimum of 1ns setup and 1ns hold time must be maintained at the input of the receiver…
    • 5 months ago
    • Interface
    • Interface forum
  • [FAQ] LMH1239: SDI Layout Suggestions

    Nick Peabody
    Nick Peabody
    Part Number: LMH1239 Other Parts Discussed in Thread: LMH1297 Tool/software: Hello SDI engineers and LMH enthusiasts, Figure 1 - 3:5 for SDI In this E2E FAQ, I will be discussing GND plane layout best practices for SDI designs. In cable driver…
    • 5 months ago
    • Interface
    • Interface forum
  • [FAQ] TDP142: Linearity Range Description

    Shane Hauser
    Shane Hauser
    Part Number: TDP142 Other Parts Discussed in Thread: TDP2004 , , TDP1204 Tool/software: Hi Experts, What does 'Linear range' refer to on re-drivers like TDP142, TDP1204, TDP2004,...?
    • Answered
    • 6 months ago
    • Interface
    • Interface forum
  • [FAQ] Device Mismarked with A5

    McKenzie Eaker
    McKenzie Eaker
    The device I received is marked as 'A5' but that is not listed as an option in the datasheet.
    • 6 months ago
    • Interface
    • Interface forum
  • [FAQ] PC -> EVM 983 -> Display with 988 -> Display with 988 -> Display with 988

    Franz Schmid
    Franz Schmid
    Part Number: DS90UB988-Q1EVM Tool/software: Hello, Is it possible to use this setup to test the daisy chain feature with the following setup: PC -> EVM 983 -> Display with 988 -> Display with 988 -> Display with 988 ~ Franz
    • 7 months ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: Why is DP83Txxxx not passing compliance?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TC812S-Q1 Other Parts Discussed in Thread: DP83TC811 Tool/software: For all 1000Base-T1 and 100Base-T1 compliance tests (including Interopability/link-up, PMA, PHY Control, PCS, and EMC), there is a required software configuration to…
    • 8 months ago
    • Interface
    • Interface forum
  • [FAQ] DP83848Q-Q1: How to Disable 25Mhz CLKOUT Output

    David Creger
    David Creger
    Part Number: DP83848Q-Q1 Tool/software: If the CLKOUT output is not used on DP83848, it may be disabled using the below register writes. This may be beneficial for EMC emissions testing, in order to minimize the energy of 25Mhz harmonics. 0x13[0] =…
    • 9 months ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: What IPG intervals can this PHY support?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Tool/software: DP83867 supports the expected 12 byte IPG at the MDI as well as lower amounts in some conditions. This number comes from IEEE802.3 section 4.4.2 which sets out that the minimum IPG for a transmitted frame is 12 bytes…
    • 9 months ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DS90UB941AS-Q1 how to set registers to support hs/vs mode? 0 Locked

    237 views
    5 replies
    Latest over 5 years ago
    by Michael.Walker
  • Not Answered

    DS90UB954-Q1: 0x7D bit7 initial value 0 Locked

    202 views
    1 reply
    Latest over 5 years ago
    by Casey McCrea
  • Suggested Answer

    TCAN4550-Q1: TCAN4550 Question for new project design 0 Locked

    361 views
    1 reply
    Latest over 5 years ago
    by Jonathan Nerger
  • Answered

    SN65LBC173A-EP: Propagation delay clarification 0 Locked

    324 views
    3 replies
    Latest over 5 years ago
    by Hao L
  • Suggested Answer

    TPD4S012: Reverse stand of f voltage of the TPD4S012DRY 0 Locked

    391 views
    1 reply
    Latest over 5 years ago
    by Matt Smith
  • Answered

    SN65DSI83: does it use in sync with the MIPI interface clock? 0 Locked

    266 views
    3 replies
    Latest over 5 years ago
    by Ikechukwu Anyiam
  • Answered

    TCAN1043-Q1: Low power fault protected 0 Locked

    256 views
    1 reply
    Latest over 5 years ago
    by Eric Hackett
  • Suggested Answer

    Replacements of ESD122 and TPD2E007 0 Locked

    477 views
    1 reply
    Latest over 5 years ago
    by dimitri james
  • Suggested Answer

    THVD1550: Termination / pull up and pull down resistor 0 Locked

    404 views
    1 reply
    Latest over 5 years ago
    by Hao L
  • Answered

    DP141RLJEVM: I2C_EN setting for GPIO mode 0 Locked

    282 views
    1 reply
    Latest over 5 years ago
    by David (ASIC) Liu
  • Not Answered

    DS250DF230: HSSTP/HTI application 0 Locked

    146 views
    1 reply
    Latest over 5 years ago
    by Rodrigo Natal
  • Answered

    DS100BR111: 10G-KR Mode Packet Loss in Receiver line 0 Locked

    287 views
    1 reply
    Latest over 5 years ago
    by Nasser Mohammadi
  • Suggested Answer

    DS90UH948-Q1: LOCK output when FPD-LINK RIN is disconnected 0 Locked

    461 views
    7 replies
    Latest over 5 years ago
    by Casey McCrea
  • Suggested Answer

    LMH1219: X7R or X5R? for 12G SDI AC coupling caps selection 0 Locked

    540 views
    1 reply
    Latest over 5 years ago
    by Nasser Mohammadi
  • Answered

    DP83630: DP83630_TPI Network Circuit 0 Locked

    247 views
    1 reply
    Latest over 5 years ago
    by Justin Lazaruk
  • Not Answered

    DP83TC811S-Q1: Switch the mode of the chip in the process of sending and receiving data 0 Locked

    176 views
    1 reply
    Latest over 5 years ago
    by Justin Lazaruk
  • Not Answered

    TCA9517: Multiple TCA9517's for I2C bus extension 0 Locked

    571 views
    2 replies
    Latest over 5 years ago
    by abeaulieu-tri
  • Suggested Answer

    DS90UB933-Q1: Sync mode extracts a ref clock from BCC and PLL 0 Locked

    184 views
    1 reply
    Latest over 5 years ago
    by Casey McCrea
  • Answered

    TUSB1042I: USB 3.0 Polarity Inversion 0 Locked

    1457 views
    2 replies
    Latest over 5 years ago
    by Malik Barton57
  • Answered

    SN55LVDS33-SP: Output Current Capability 0 Locked

    221 views
    1 reply
    Latest over 5 years ago
    by Ikechukwu Anyiam
<>