TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] RS232 and RS485 Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page RS232 and RS485 Protection Highlights: RS-485 – Industry standard protocol for data transfer from sensors, etc. Drive capability of minimum 32 unit loads (UL, 12kΩ) Uses two signal lines A & B which must be balanced…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Peripheral Component Interconnect Express (PCIe) Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page PCIe Protection Highlights: PCIe: High speed serial bus expansion standard Slots come in different sizes: x1, x4, x8, x16, x32, x64 Each lane has two differential signaling pairs (Tx, Rx) PCIe Gen 5 bandwidth…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LIN Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page LIN Protection Highlights: LIN: Single ended data transfer interface LIN clusters consist of 1 master and up to 16 slave nodes Construction: One wire for data transfer + ground Bidirectional configuration is…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] I2C Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page I2C Protection Highlights: 2 Lines to Protect Low Capacitance required to minimize signal interference Speeds up to 5Mbps TI Products Recommendations Working Voltage (V) IEC 61000-4-2 ESD…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Human-Machine Interface (HMI) Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page Human-Machine Interface (HMI) Protection Highlights: Protection needed for interfaces exposed to human contact Pushbuttons Keypads Touchscreens Any other points of frequent contact Operating Voltage…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] HDMI Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page HDMI Protection Highlights: High speed media, data transfer interface with 6 control lines & 8 data lines Operating voltage: For each data and control line, 3.3V and 5V respectively This requires a protection…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] GPIO Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page GPIO Protection Highlights: Operating Lines: I/Os Dataline operating voltage: 1.8 - 3.3 V, recommended breakdown > 3.6 V Capacitance is not a huge concern < 30 pF Multi-channel recommended for multiple I/Os…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] FPD-Link Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page FPD-Link Protection Highlights: FPD Link: Digital audio/video transfer protocol used in video screens or for driver assistance cameras in Automobiles, etc., Mode of operation: Single ended & differential mode …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DP83867CR: Force Link Good bit was asserted. Why? 0 Locked

    780 views
    7 replies
    Latest over 5 years ago
    by Vikram Sharma
  • Suggested Answer

    DP83867IRPAP-EVM: DP83867IRPAP-EVM 0 Locked

    486 views
    1 reply
    Latest over 5 years ago
    by Vikram Sharma
  • Suggested Answer

    SN65HVD235: Mix 3.3V CAN and 5V CAN in same CAN bus 0 Locked

    953 views
    1 reply
    Latest over 5 years ago
    by Miguel Robertson
  • Suggested Answer

    SN65LVDS93A-Q1: Is the side surface of pins able to wet the solder? 0 Locked

    266 views
    1 reply
    Latest over 5 years ago
    by Charley Cai
  • Suggested Answer

    LMH0341: Reference design /reference layout 0 Locked

    443 views
    3 replies
    Latest over 5 years ago
    by Nasser Mohammadi
  • Not Answered

    TUSB546-DCI: eDP couldnt input in GPIO mode 0 Locked

    463 views
    6 replies
    Latest over 5 years ago
    by Malik Barton57
  • Answered

    SN65HVD10: Date codes for SN65HVD10QD 0 Locked

    997 views
    8 replies
    Latest over 5 years ago
    by Sergio82
  • Suggested Answer

    SN65HVD3082E: RS485 SN65HVD3082EDR undershoot while TX enable 0 Locked

    2638 views
    14 replies
    Latest over 5 years ago
    by Hao L
  • Not Answered

    DP83848VYB: EMI problems on 200 & 250 MHz 0 Locked

    364 views
    2 replies
    Latest over 5 years ago
    by Vikram Sharma
  • Suggested Answer

    DP83822I: DP83822I Bootstrap Hardware Configuration Timing 0 Locked

    713 views
    4 replies
    Latest over 5 years ago
    by Vikram Sharma
  • Suggested Answer

    DS90UB925Q-Q1: INPUT SIGNAL RGB565 0 Locked

    434 views
    1 reply
    Latest over 5 years ago
    by Casey McCrea
  • Suggested Answer

    DS90UR905Q-Q1: RGB565 input signal 0 Locked

    628 views
    1 reply
    Latest over 5 years ago
    by Casey McCrea
  • Suggested Answer

    DS90UB948-Q1: Can Host CPU communicate and control remote I2C slaves connected with DS90UB948 Deserializer? 0 Locked

    15030 views
    2 replies
    Latest over 5 years ago
    by Casey McCrea
  • Answered

    DS26C31T: ESD Rating 0 Locked

    290 views
    2 replies
    Latest over 5 years ago
    by Jonathan Geronga
  • Answered

    HD3SS214: DP lane swap and PN polarity swap support 0 Locked

    1352 views
    1 reply
    Latest over 5 years ago
    by David (ASIC) Liu
  • Answered

    SN65HVD256: Schematic Design 0 Locked

    802 views
    1 reply
    Latest over 5 years ago
    by Miguel Robertson
  • Suggested Answer

    SN65C1167E: use SN65C1167E for long-distance of SPI w/ multi slave 0 Locked

    401 views
    1 reply
    Latest over 5 years ago
    by Miguel Robertson
  • Answered

    TCA6416A: I/O expander with bus isolation 0 Locked

    1284 views
    2 replies
    Latest over 5 years ago
    by AJ
  • Not Answered

    DS92LV3222: Ser/Des Problem 0 Locked

    463 views
    9 replies
    Latest over 5 years ago
    by Steven(Shenzhen) Shi
  • Suggested Answer

    TPD12S016: need level shifters 0 Locked

    328 views
    2 replies
    Latest over 5 years ago
    by Michael Tan
<>