TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS90UB960-Q1: BIST Duration

    ReedKacz
    ReedKacz
    Part Number: DS90UB960-Q1 Hi Team, What is the recommended duration to run the BIST? Thanks Reed
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select correct RGMII delay mode for PHY and MAC?

    Vikram Sharma
    Vikram Sharma
    RGMII standard asks for the introduction of delay in the clock (RX_CLK/TX_CLK) with respect to the respective data (RX_D*/RX_CTRL or TX_D*/TX_CTRL). This delay can be introduced at the source of the clock or at the receiver side. Following table should…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select the crystal's ppm specification for an Ethernet system?

    Vikram Sharma
    Vikram Sharma
    Other Parts Discussed in Thread: DP83TC811 Ethernet data travels effectively from one MAC to another MAC with two Ethernet PHYs in between. Each of these 4 ICs can have their own reference clocks and crystal attached to each is the usual source of this…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: DP83867 digital loopback fail, how to set MII and PCS loopback

    Richard Yang1
    Richard Yang1
    Part Number: DP83867IR Hi Team: Customer side need our help to find the root cause of DP83867 Communication failure issue from one failed board . could you please help to take a look at the attached , customer need to know How to enable MII and PCS…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] RGMII Timing - Align and Shift mode

    Gokul Koraganji
    Gokul Koraganji
    Definitions: TX_DATA[3:0], TX_CLK (naming of TI Ethernet PHYs) are transmitted by the MAC/(Repeater PHY) and RX_DATA[3:0], RX_CLK (naming of TI Ethernet PHYs) are transmitted by Ethernet PHY. S.No Mode Definition 1 PHY: RX Align…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UB933-Q1: DS90UB933-Q1 and DS90UB913A-Q1 MODE Decode

    Casey McCrea
    Casey McCrea
    Part Number: DS90UB933-Q1 Other Parts Discussed in Thread: DS90UB913A-Q1 , How do I determine if the DS90UB933-Q1 or DS90UB913A-Q1 device is operating in RAW10, RAW12LF, or RAW12HF through registers?
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] Demystifying Surge Protection

    Matt Smith
    Matt Smith
    Please refer to the links below to access our content related to Demystifying Surge Protection: Videos https://training.ti.com/getting-started-interface-protection White paper https://www.ti.com/lit/pdf/slyy152
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] ESD Fundamentals Training

    Matt Smith
    Matt Smith
    Please refer to the links below to access our ESD Fundamentals training: Videos https://training.ti.com/getting-started-interface-protection Blog Posts Part 1: https://e2e.ti.com/blogs_/b/powerhouse/posts/esd-fundamentals-part-1-what-is…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] ESD and TVS Protection Devices: Key Collateral and FAQs

    Matt Smith
    Matt Smith
    Please use the links below to access our top collateral/FAQs to learn all about protection devices, ESD and surge standards, and how to properly protect your system from ESD and surge events. [FAQ] What TI ESD/TVS diode should I use to protect Interfaces…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select TI High Speed Mux devices?

    Brian Zhou
    Brian Zhou
    There are many Mux devices in TI high speed portfolio, sometimes it's not easy to select a right part for a particular application. This FAQ is used to help FAE or customer to choose the right Mux device based on Mux performance, channel numbers, protocols…
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DS90UH949A-Q1: DS90UH949A-Q1 - maximum cable length 0 Locked

    664 views
    7 replies
    Latest over 6 years ago
    by Casey McCrea
  • Answered

    TFP410: YCbCr to HDMI Bridge 0 Locked

    819 views
    1 reply
    Latest over 6 years ago
    by Ikechukwu Anyiam
  • Answered

    DS280BR810: Data rate 0 Locked

    431 views
    4 replies
    Latest over 6 years ago
    by Michael Colbert
  • Answered

    Request solution of PCIe switch. 0 Locked

    2305 views
    4 replies
    Latest over 6 years ago
    by Lee Sledjeski
  • Suggested Answer

    TUSB422: May we have QC3.0 + TypeC combine solution?(we request role is UFP) 0 Locked

    243 views
    1 reply
    Latest over 6 years ago
    by Gerasimos Madalvanos
  • Suggested Answer

    AM26LV31E: output voltage will be 3.3v or 5v 0 Locked

    855 views
    7 replies
    Latest over 6 years ago
    by Miguel Robertson
  • Answered

    PCA9306: PCA9306 Vref1=1.5V and Vref2=3.3V 0 Locked

    420 views
    1 reply
    Latest over 6 years ago
    by Miguel Robertson
  • Suggested Answer

    THS8200: Design questions 0 Locked

    222 views
    1 reply
    Latest over 6 years ago
    by Cvetolin Shulev-XID
  • Answered

    TPS65982: Current sense details 0 Locked

    321 views
    3 replies
    Latest over 6 years ago
    by Eric Beljaars
  • Answered

    DS90UB941AS-Q1: What is the differential signal pair required for screen resolution? 0 Locked

    304 views
    3 replies
    Latest over 6 years ago
    by Hamzeh Jaradat
  • Suggested Answer

    TPS65982 : minidock project correct ? 0 Locked

    243 views
    1 reply
    Latest over 6 years ago
    by Eric Beljaars
  • Answered

    TPS65987D: Application Customization Tool 0 Locked

    247 views
    1 reply
    Latest over 6 years ago
    by Eric Beljaars
  • Answered

    DS90UB935-Q1: Using CSI-2 non-synchronous CLK_IN mode in DVP mode 0 Locked

    1787 views
    22 replies
    Latest over 6 years ago
    by Nao
  • Answered

    DS90UH929-Q1: EMI Data 0 Locked

    344 views
    4 replies
    Latest over 6 years ago
    by Nao
  • Answered

    DS90UH929-Q1: Power supply for internal PLL 0 Locked

    396 views
    4 replies
    Latest over 6 years ago
    by Nao
  • Suggested Answer

    TVP5158: Alternative part 0 Locked

    335 views
    2 replies
    Latest over 6 years ago
    by Michail Georgiev
  • Suggested Answer

    DP83867IR: RGMII Timing Diagram 0 Locked

    338 views
    1 reply
    Latest over 6 years ago
    by Aniruddha Khadye
  • Answered

    DP83867IR: DP83867IRPAP RGMII link failed 0 Locked

    607 views
    4 replies
    Latest over 6 years ago
    by noah zhu
  • Answered

    TUSB2046B: TUSB2046B,Can't communicate 0 Locked

    428 views
    2 replies
    Latest over 6 years ago
    by Neal Zhu
  • Suggested Answer

    DP83869EVM: Switch from 100BASE-FX to 1000BASE-X without rebooting the EVM? 0 Locked

    541 views
    6 replies
    Latest over 6 years ago
    by Hung Nguyen92
<>