TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] RS232 and RS485 Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page RS232 and RS485 Protection Highlights: RS-485 – Industry standard protocol for data transfer from sensors, etc. Drive capability of minimum 32 unit loads (UL, 12kΩ) Uses two signal lines A & B which must be balanced…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    DS90UB941AS-Q1: how to configure SPI pass through to 948 0 Locked

    48 views
    1 reply
    Latest 1 month ago
    by Ragav Subramanian
  • Answered

    DP83867CS: PHY in Mirror Mode 0 Locked

    61 views
    1 reply
    Latest 1 month ago
    by Shane Hauser
  • Answered

    PCF8574: Input voltage/current specifications 0 Locked

    479 views
    32 replies
    Latest 1 month ago
    by Tyler Townsend
  • Suggested Answer

    TLIN1028-Q1: Question about test report of TLIN10285DDARQ1 0 Locked

    77 views
    3 replies
    Latest 1 month ago
    by Michael Ikwuyum
  • Suggested Answer

    TLIN1028-Q1: Question about ISO standards of TLIN1028-Q1 0 Locked

    91 views
    3 replies
    Latest 1 month ago
    by Michael Ikwuyum
  • Answered

    TRS3232E: VCC=2.4V 0 Locked

    37 views
    3 replies
    Latest 1 month ago
    by Eric Hackett
  • Suggested Answer

    TCAN1043HG-Q1: Cap selection 0 Locked

    169 views
    6 replies
    Latest 1 month ago
    by Beida Song
  • Answered

    TLIN2029A-Q1: differences to TLIN2029-Q1 0 Locked

    44 views
    1 reply
    Latest 1 month ago
    by Matt Smith
  • Suggested Answer

    TCA9548A: I2C MUX channels are not detecting when any one of the slave device is OFF 0 Locked

    152 views
    10 replies
    Latest 1 month ago
    by Katy West
  • Answered

    SN75LBC184: SN75LBC184D die vs SN65LBC184DR 0 Locked

    58 views
    1 reply
    Latest 1 month ago
    by BOBBY
  • Answered

    MAX3232: PN# MAX3232MPWREP - Question regarding trace code 0 Locked

    45 views
    1 reply
    Latest 1 month ago
    by BOBBY
  • Suggested Answer

    TPD1S414: Serial resistor value 0 Locked

    105 views
    3 replies
    Latest 1 month ago
    by Ke Wang
  • Not Answered

    ESD441: Clamping voltage with surge strike @Ipp=1A 0 Locked

    32 views
    1 reply
    Latest 1 month ago
    by Josh Prushing
  • Answered

    DP83TG720EVM-MC: Operating temperature range? 0 Locked

    93 views
    4 replies
    Latest 1 month ago
    by Jae Won Jo
  • Answered

    DP83867IR: About new revision detail 0 Locked

    66 views
    1 reply
    Latest 1 month ago
    by J
  • Suggested Answer

    PCA9306: PCA9306 Vrerf 1.2V-> Vref 0.9V operation's verification 0 Locked

    44 views
    1 reply
    Latest 1 month ago
    by Tyler Townsend
  • Answered

    DP83TC812S-Q1: DP83TC812S-Q1 SGMII AC capacitors clarification 0 Locked

    46 views
    1 reply
    Latest 1 month ago
    by Undrea Fields
  • Suggested Answer

    TCAN1044A-Q1: CAN /CAN FD Physical Layer 0 Locked

    67 views
    1 reply
    Latest 1 month ago
    by Michael Ikwuyum
  • Suggested Answer

    DS90UB971-Q1: DS90UB971-Q1 0 Locked

    108 views
    4 replies
    Latest 1 month ago
    by Myungjin Ko
  • Answered

    DS90UB948-Q1EVM: DS90UB948-Q1EVM 0 Locked

    62 views
    2 replies
    Latest 1 month ago
    by john chou
<>