Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] DP83869HM: Link ok vs Link status signal

    Part Number: DP83869HM Tool/software: Hi Team, What is the difference between link ok and link status in the 869 data sheet?

  • [FAQ] LIN Transceiver Resources

    [Click here to return to Transceiver Homepage] Welcome to the LIN Transceivers E2E page! Listed below are a variety of resources to assist with the implementation of Local Interconnect Network, also know as LIN! LIN Basics: LIN Overview…

  • [FAQ] LVDS / M-LVDS Transceiver Resources

    [Click here to return to Transceiver Homepage] Welcome to the LVDS / M-LVDS Transceivers E2E page! Listed below are a variety of resources to assist with the implementation of Low Voltage Differential Signaling, also know as LVDS! LVDS / M-LVDS…

  • [FAQ] RS-485 / RS-422 Transceiver Resources

    [Click here to return to Transceiver Homepage] Welcome to the RS-485 / RS-422 Transceivers E2E page! Listed below are a variety of resources to assist with the implementation of RS-485 and RS-422! Note that many RS-485 resources also apply to RS…

  • [FAQ] LMH1297: Manually Adjusting Cable EQ

    Part Number: LMH1297 Tool/software: Hi, When performing diagnostic evaluations of the LMH1297 retimer customers often want to adjust input cable EQ from the IO side. In these cases we recommend disabling the EQ adaptation and performing the following…

  • [FAQ] CAN Transceiver Resources

    [Click here to return to Transceiver Homepage] Welcome to the CAN Transceivers E2E page! Listed below are a variety of resources to assist with the implementation of the Controller Area Network, aka CAN! Frequently Asked Questions (FAQs):…

  • [FAQ] Interface Transceivers: E2E Homepage

    Welcome to the Interface Transceivers E2E page! Here you will find a variety of resources that support our long list of devices (750+ and counting!) Select an interface below to find a collection of FAQs, application notes, videos, and more: …

  • [FAQ] DS320PR810: How should PCIe signals be AC coupled?

    Part Number: DS320PR810 Other Parts Discussed in Thread: DS320PR1601 , DS160PR1601 Tool/software: How do I check to make sure my PCIe signals are AC-coupled correctly?

  • [FAQ] DP83TC812S-Q1: RGMII Shift and Align Mode

    Part Number: DP83TC812S-Q1 Tool/software: Hello, Here is a summary of available information about RGMII Shift and Align mode for our DP83TC81x devices: A minimum of 1ns setup and 1ns hold time must be maintained at the input of the receiver…

  • [FAQ] LMH1239: SDI Layout Suggestions

    Part Number: LMH1239 Other Parts Discussed in Thread: LMH1297 Tool/software: Hello SDI engineers and LMH enthusiasts, Figure 1 - 3:5 for SDI In this E2E FAQ, I will be discussing GND plane layout best practices for SDI designs. In cable driver…

View FAQ threads