• Threads 52460 Discussions
Texas Instruments (TI) Microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search for content on other microcontrollers or ask technical support questions on the extensive portfolio of microcontrollers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TMS570LC4357: Listing out the bugs in the Cyclic Redundancy Check (CRC) Controller Module

    Part Number: TMS570LC4357 Tool/software: Here i am listing out the all the bugs in the Cyclic Redundancy Check (CRC) Controller Module for both little endian (e.g. RM57Lx) and big endian (e.g. TMS570LC43x) devices of Hercules family.

  • [FAQ] TMDSCNCD263: AM243x to AM263x/AM263Px CPSW guide

    Part Number: TMDSCNCD263 Hi experts, Is the CPSW on the TI AM243x, TI AM263x and TI AM263Px same? Are there any differences in the hardware functionality and software offering? Can you please explain the differences in detail. Thanks

  • [FAQ] AM2634: Issues in receiving/sending multicast frames on AM26x devices

    Part Number: AM2634 Hi experts, I send a multicast frame from the AM26x device but it is not visible on wireshark I send a multicast frame to the AM26x device but my application does not receive it. Is there an issue in the CPSW hardware or…

  • [FAQ] TMS570LC4357: Issues with application Interrupts when using a Bootloader

    Part Number: TMS570LC4357 Hi All, I'm trying to use the UART Bootloader to download and start my application. Everything seems to be working fine except for the interrupts. I read from other forums that I need to change the intvecs.asm file in my…

  • [FAQ] AM2634: MCAL Ethernet Polling and Interrupt mode

    Part Number: AM2634 Hi experts, I am using the out-of-box MCAL Eth app demo How do I disable interrupt pacing in my MCAL Ethernet project How do I switch to polling mode instead of interrupt mode.

  • [FAQ] LP-MSPM0G3507: What Programming Tools are Supported for MSPM0?

    Part Number: LP-MSPM0G3507 What Programming Tools are supported for development with MSPM0?

  • [FAQ] MCU-PLUS-SDK-AM26X: [FAQ] AM26x: CCS project for ASM MCAL

    Part Number: MCU-PLUS-SDK-AM263X H ow to enable and import CCS project in ASM MCAL?

  • [FAQ] AM2634: Integration of PHY driver on custom board

    Part Number: AM2634 Hi experts, Can you guide me on how to add PHY drivers on my custom board?

  • [FAQ] UNIFLASH: How to use UniFlash command line interface with MSPM0 device (load images and read memory)

    Part Number: UNIFLASH Other Parts Discussed in Thread: MSPM0G3507 , MSPM0L1306 UniFLash supports command line interface (CLI) to load images and read memory of the device. Please refer to below user guide for details information of the CLI: https…

  • [FAQ] MCU-PLUS-SDK-AM263X: What are the difference types of reset in the SoC ?

    Part Number: MCU-PLUS-SDK-AM263X What is the difference between L_RST, G_RST, FSM reset? What are a warm reset and a cold reset? What is the SoC Boot Flow for each reset?

View FAQ threads