TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] TPS7H5001-SP: How do I use the TPS7H500X-SP family as a voltage mode controller?

    Daniel Hartung
    Daniel Hartung
    Part Number: TPS7H5001-SP The TPS7H500X-SP family of devices are innately set-up for current mode control. Am I able to use the controller as a voltage mode controller?
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ24610: What is the proper placement of bypass capacitors on VREF, VCC, and REGN for BQ24610 and other BQ246xx devices?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24610 Please place all decoupling capacitors as close as possible to the IC pin they correspond to (following the Layout Guidelines and priorities for each device). However, please make sure that the VREF, VCC, and REGN pins are not loaded…
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS23731: Vout setting on diode rectification and primary-side regulation (affect by VFCP)

    Satoshi
    Satoshi
    Part Number: TPS23731 I considering TPS23731 with diode rectification and primary-side regulation, referenced by answered below E2E thread. https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1169390/tps23731…
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87745-Q1: Where can I find functional safety documents and full data sheet?

    Ishtiaque Panhwar
    Ishtiaque Panhwar
    Part Number: LP87745-Q1 The functional safety documents and full data sheet can be requested through following request link on product folder at https://www.ti.com/product/LP87745-Q1?keyMatch=LP8774-Q1 . Thanks!
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87745-Q1: What is the naming convention of device part number?

    Ishtiaque Panhwar
    Ishtiaque Panhwar
    Part Number: LP87745-Q1 It is explained as following; LP8774 x x xx RXV R Q1 x : Number of regulators x : Switching Frequency (Fsw) and BOM/performance optimized options (1,2,or 3) LP8774x 1 : 17.6 MHz + full performance option or BOM/cost…
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8758-B0: Can TI provide a solution size for the device?

    Phil Yi
    Phil Yi
    Part Number: LP8758-B0 Yes; the EVM design linked below can provide a reference of the solution size for these devices in every phase configurations: https://www.ti.com/tool/LP8758EVM?keyMatch=&tisearch=search-everything&usecase=hardware The picture…
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8758-E0: Does TI have other existing OTP variants for quicker and easier samples?

    Phil Yi
    Phil Yi
    Part Number: LP8758-E0 Yes; listed in table picture below are existing OTP variants available for samples. Any new OTP variant needs to meet certain business size to start the process; please contact your local TI sales for more details.
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LM26480: Is there a reference design of power up sequence implemented by RC delay on EN pin?

    Phil Yi
    Phil Yi
    Part Number: LM26480 Yes; a set of RC (Resistor and Capacitor) values were used on TI LM26480 EVM with VCC=3.3V on 3 "EN" pins (ENSW2, ENLDO1, ENLDO2) to control the power up delay for the sequence. ENSW1 connects to VCC directly without RC delay. …
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ76952: Mask registers for Alarm Raw Status

    Francis Jiang
    Francis Jiang
    Part Number: BQ76952 Hi Team, I would like to ask a question: what is the mask registers? I am confused about the following words: Thanks a lot. BRs, Francis
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS43330A-Q1: TPS43330 EMC Comparison between SS (Spread Spectrum) Disable/Enable

    Phil Yi
    Phil Yi
    Part Number: TPS43330A-Q1 TPS43330 EMC Comparison for SS.pdf
    • over 2 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    BQ25710: CELL_BATPRES pin configuration for 10 cell NiMH pack. 0 Locked

    279 views
    2 replies
    Latest over 6 years ago
    by Elder Costa17
  • Suggested Answer

    TPS2378: When use a 802.3AT PSE tps2378 can work,when use a 802.3af PSE,it will not work 0 Locked

    2020 views
    8 replies
    Latest over 6 years ago
    by Darwin Fernandez
  • Suggested Answer

    TPS3852: Working procedure 0 Locked

    886 views
    11 replies
    Latest over 6 years ago
    by Marcoo Z
  • Answered

    BQ25882: Unused Pins 0 Locked

    214 views
    1 reply
    Latest over 6 years ago
    by Jeff F
  • Answered

    TPS65910: VRTC is displayed in Power Down mode or Sleep mode. 0 Locked

    478 views
    3 replies
    Latest over 6 years ago
    by Brian Berner
  • Suggested Answer

    BQ24715: how to set ship mode of BQ24715 0 Locked

    389 views
    1 reply
    Latest over 6 years ago
    by Jeff F
  • Suggested Answer

    TPS54140A: Vout Ripple in case of a small Load (pulse skip mode) 0 Locked

    671 views
    2 replies
    Latest over 6 years ago
    by Orlando Murray
  • Suggested Answer

    TPS23754: TPS23754EVM-420 EVM 0 Locked

    1113 views
    11 replies
    Latest over 6 years ago
    by Darwin Fernandez
  • Suggested Answer

    BQ76PL455A-Q1: BQ76PL455A-Q1 daisy chain questions, fail reading cascading device address 0 Locked

    388 views
    1 reply
    Latest over 6 years ago
    by Leslie Marquez
  • Answered

    TPS92690: Resistive Load Loop Stabilization 0 Locked

    454 views
    5 replies
    Latest over 6 years ago
    by Kevin Schmidgall
  • Suggested Answer

    ISO5452: What is the value of internal Pull-down resistor and pull-up resistor? 0 Locked

    425 views
    3 replies
    Latest over 6 years ago
    by Xiong Li
  • Suggested Answer

    WEBENCH® Tools/TPS54541: webench design validity for TPS54541 0 Locked

    374 views
    3 replies
    Latest over 6 years ago
    by David Baba
  • Suggested Answer

    WEBENCH® Tools/LM5023: Multiple output dc dc converter design on Web Bench 0 Locked

    1105 views
    3 replies
    Latest over 6 years ago
    by Amod Vaze
  • Suggested Answer

    LM5145: What happens if the RT pin is left floating? 0 Locked

    345 views
    3 replies
    Latest over 6 years ago
    by Timothy Hegarty
  • Suggested Answer

    TPS92691 0 Locked

    243 views
    2 replies
    Latest over 6 years ago
    by Tuan Tran74
  • Answered

    LMZ34202EVM: PCB dimensions 0 Locked

    319 views
    1 reply
    Latest over 6 years ago
    by Jimmy Hua
  • Not Answered

    Looking for assistance to find the IO chart for an old TI chip, any recommendation on where to look 0 Locked

    645 views
    1 reply
    Latest over 6 years ago
    by LeonardEllis
  • Suggested Answer

    TPS92692-Q1: SS Connects 100nF Capacitor to GND 0 Locked

    242 views
    1 reply
    Latest over 6 years ago
    by Tuan Tran74
  • Answered

    TPS544C20: Tolerance of start-up time 0 Locked

    192 views
    2 replies
    Latest over 6 years ago
    by Mathew Jacob1
  • Answered

    BQ25898: charging current bouncing during the CV stage 0 Locked

    1307 views
    19 replies
    Latest over 6 years ago
    by mike zhang
<>