TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] TPS53353: PGOOD pin connected to an external voltage source and/or MCU/FPGA monitor effects on the MODE settings

    Alec Biesterfeld
    Alec Biesterfeld
    Part Number: TPS53353 Other Parts Discussed in Thread: TPS53355 With PGOOD pulled up externally to an MCU or FPGA and an external voltage source, I would not expect any issues in the soft-start/mode selection so long as the probe monitoring PGOOD is…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How to add DESAT or short circuit protection to gate drivers

    Gabriel Xu
    Gabriel Xu
    Part Number: UCC21530-Q1 Other Parts Discussed in Thread: UCC21759-Q1 , UCC21750 , UCC21739-Q1 , UCC21732-Q1 , ISO5851 , ISO5851-Q1 , ISO5852S-EP , ISO5852S-Q1 , UCC21710 , ISO5852S , UCC21710-Q1 , UCC21732 , UCC21736-Q1 , UCC21750-Q1 , UCC5390 , UCC21520…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] End of life (applies to ALL TI devices)

    mustafa Ehsan
    mustafa Ehsan
    Other Parts Discussed in Thread: LMG1210 Hi, I want to use the LMG1210 for a new design, but I want to make sure that I can manufacture the part for a few years to come. My question is when was the LMG1210 released and when will it reach it's end-of…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS54824: What is the startup process in terms of FB, SS/TRK and COMP pins?

    Eileen Hernandez Hernandez
    Eileen Hernandez Hernandez
    Part Number: TPS54824 The device has been designed to prevent the low-side MOSFET from discharging a pre-biased output. During monotonic pre-biased startup, the low-side MOSFET is not allowed to sink current until the SS/TRK pin voltage is higher than…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS54A24: How to reduce noise at Vin, Vout and when taking measurements?

    Eileen Hernandez Hernandez
    Eileen Hernandez Hernandez
    Part Number: TPS54A24 Noise reduction for VIN and VOUT There are things which can be done to reduce this noise such as adding a boot resistor or snubber, adding input or output caps for high frequency bypass or adding some inductive filtering. Noise…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] LM5141: loop compensation

    Elec Cheng
    Elec Cheng
    Part Number: LM5141 Hi there, about LM5141 test, I have some questions. 1. Equation(60) shows calculating Rcomp, how this equation comes from? any more detialed deduction? 2.when inductor is too large, loop instability occurs. You said it's because…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why ADC monitoring sometimes does not work when battery only for BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ25898C?

    Ning T
    Ning T
    Part Number: BQ25890 Other Parts Discussed in Thread: BQ25898 , BQ25896 , BQ25895 , BQ25898D , BQ25898C , BQ25892 , , , BQ25895M Hi, When only the battery is present, ADC monitoring works only when the battery voltage is above the MINSYS register…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How to terminate or set the termination current of the buck-boost charger controller for BQ25710, BQ25720, BQ25730 etc.?

    Pengzhao Zhu
    Pengzhao Zhu
    Other Parts Discussed in Thread: BQ25720 , BQ25730 , BQ25710 , BQ25703A , BQ25713 , BQ25731 , BQ25700A , BQ25708 , BQ25723 , BQ25713B How to terminate or set the termination current of the buck-boost chargers?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Which buck-boost charge controller should I select for my charging application in BQ25700x, BQ25710, BQ25720 and BQ25730 families?

    Pengzhao Zhu
    Pengzhao Zhu
    Which buck-boost charge controller should I select for my charging application?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How do I ensure the charger layout is satisfactory? Is there a guideline for the buck-boost charger controllers like BQ25713, BQ25720 and BQ25730 etc.?

    Pengzhao Zhu
    Pengzhao Zhu
    Other Parts Discussed in Thread: BQ25720 , BQ25713 , BQ25730 , BQ25703A , BQ25731 , BQ25710 , BQ25700A , BQ25708 , BQ25723 , BQ25713B How do I ensure the charger layout is satisfactory? Is there a guideline for the buck-boost charger controllers like…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    TPS61099: Output Specs at Low Load (<10uA) 0 Locked

    698 views
    2 replies
    Latest over 8 years ago
    by NJC
  • Not Answered

    TL431A: Unencrypted PSpice model for TL431AQDBZR 0 Locked

    689 views
    1 reply
    Latest over 8 years ago
    by Marcoo Z
  • Not Answered

    BQ27441-G1: BQ27441-G1A 0 Locked

    596 views
    1 reply
    Latest over 8 years ago
    by Onyx Ahiakwo
  • Answered

    BQ76920: Failure to acknowledge address 0 Locked

    1041 views
    1 reply
    Latest over 8 years ago
    by WM5295
  • Answered

    TPS7B4253-Q1: 8-pin package: time between enable is tirggered and regulation starts 0 Locked

    415 views
    1 reply
    Latest over 8 years ago
    by David Hopkins
  • Suggested Answer

    Solar battery Charger, how to calculate Light Intensity ? 0 Locked

    997 views
    4 replies
    Latest over 8 years ago
    by Raheem
  • Answered

    BQ24190: bq24190 / Deglitch time from VBAT_DPL detected to BATFET turn off 0 Locked

    429 views
    1 reply
    Latest over 8 years ago
    by ParkerHolloway
  • Not Answered

    BQ34Z950: [NR] bit in DF.Configuration_1 0 Locked

    1370 views
    8 replies
    Latest over 8 years ago
    by Onyx Ahiakwo
  • Not Answered

    LM1085: Reliability information and Qual report 0 Locked

    855 views
    3 replies
    Latest over 8 years ago
    by David Hopkins
  • Answered

    LM317M: LM317MDCY Schematics Review 0 Locked

    1409 views
    5 replies
    Latest over 8 years ago
    by David Hopkins
  • Not Answered

    Quest for 8320 EP 3233 0 Locked

    1413 views
    6 replies
    Latest over 8 years ago
    by David Hopkins
  • Answered

    TLV713P-Q1: FMEA data 0 Locked

    895 views
    3 replies
    Latest over 8 years ago
    by David Hopkins
  • Not Answered

    WEBENCH® Tools/TPS40210: WEBENCH Issue 0 Locked

    376 views
    2 replies
    Latest over 8 years ago
    by Richard Elmquist
  • Suggested Answer

    TPS92661-Q1: TPS92661-Q1: Circuit configuration questions 0 Locked

    753 views
    1 reply
    Latest over 8 years ago
    by Clinton Jensen
  • Not Answered

    LM317: Input and output filter Electrolytic cap selection 0 Locked

    902 views
    1 reply
    Latest over 8 years ago
    by David Hopkins
  • Suggested Answer

    TLV713: Unencrypted Pspice model for TLV71320DQNR 0 Locked

    476 views
    1 reply
    Latest over 8 years ago
    by David Hopkins
  • Answered

    UCC28950: How does the RSUM signal of the UCC28950 affect the current limit in voltage mode. 0 Locked

    1067 views
    2 replies
    Latest over 8 years ago
    by Chuck Sampson
  • Suggested Answer

    Thermal shutdown of LP5907 0 Locked

    387 views
    1 reply
    Latest over 8 years ago
    by David Hopkins
  • Not Answered

    TPS1H100-Q1: don't operation 0 Locked

    507 views
    3 replies
    Latest over 8 years ago
    by Aleksandras_Kaknevicius
  • Suggested Answer

    LMZ34002: LMZ34002 3D stp model 0 Locked

    632 views
    1 reply
    Latest over 8 years ago
    by J Arrigo
<>