Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625
I am using a TI processor with a PRU subsystem. I want to add an additional interface to my processor (e.g., UARTs, SPIs, I2S, etc), or a custom protocol (e.g., parallel SPIs, proprietary bus protocol, etc). Can I use the PRU cores…
Part Number: TDA4VM Other Parts Discussed in Thread: INA226
Hi,
How to do Power Benchmarking (Power consumption in Watt) for supported deep learning models (Object Detection, Classification, Segmentation) on TDA4VM SoC ?
Thanks for help.
Part Number: TDA4VM
How to get EB studio tool for MCAL development and If you want to run the EB Tresos Configurator for TDA4VM MCAL, a customer license is required. How can I obtain this?
Part Number: AM6442
Hello TI experts,
I want to make the SOC reset from software. How can I do it?
What is the difference between POR (power on reset) and warm reset?
This FAQ mainly explains how to Reset the SOC. And what are the registers used…
Part Number: PROCESSOR-SDK-J721E By default, McSPI/SPI Drivers in PSDKRA uses packet descriptors for transferring or for receiving data to/from the SPI slave device. Sometimes it might require to use TR descriptors, because TR supports additional functionalities…
Part Number: AM62A7-Q1
SD cards is not need in our project using AM62A7-Q1. if SD card is not used, how to connect the pin net VDDSHV4, VDDSHV5, and VDDSHV6 of AM62A7-Q1? leave it open or connected directly to VSS or ?
